ASSEMBLY
5LOWER CHUTE
(See Figure 5)
1.Turn mower engine off.
2.Raise and hold deflector shield in upright position.
2.Place slot in lower chute over tab on mower deck and position lower chute over deck opening as shown.
3.Hook rear latch into flange hole on back of mower deck.
4.Hook front latch into tab hole on front of mower deck.
CAUTION
Before raising deflector shield, turn mower engine off. DO NOT remove deflector shield from mower. Raise and hold shield when at- taching lower chute and allow it to rest on chute while in operation.
DEFLECTOR
SHIELD
TAB
FRONT
LATCH
REAR LATCH
FIGURE 5
6 UPPER CHUTE (See Figures 6A & 6B)
1.Lower mower deck to its lowest cutting position.
2.Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage dump bag indicator.
3.Push in and turn upper chute until it is in line with lower chute.
4.Align the bosses on lower chute with align- ment slots on upper chute with alignment slots on upper chute and slide together.
5.Secure with rubber latch by hooking hole in latch over latch pin.
DUMP BAG
UPPER INDICATOR HANDLE CHUTE
COVER
LOWER
CHUTE
FIGURE 6A
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
BOSSES
FIGURE 6B
7LEVEL MOWER DECK
Be sure deck is properly leveled for best mower performance. See your mower operator’s manual for instructions.
9