Husqvarna YTH1542XPT owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Image 24
Contents YTH1542XPT Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See FigsTo Remove Mower See Fig To Level Mower Mower Drive Belt Installation To Replace Mower Drive Belt See FigMower Drive Belt Removal To Replace Motion Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Replace Headlight Bulb Interlocks and RelaysTo Remove Hood and Grill Assembly See Fig To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor Model NO. YTH1542XPT 96043000602, Product no 43Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive KEY Part NO. NO. Description Steering Assembly Spark Arrester KIT EngineSeat Assembly Tractor Model NO. YTH1542XPT 96043000602, Product no 43 00 Wheels and TiresMower Deck KEY Part NO. NO. Description Mower Lift Service Notes Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement 532 40 64-54 10.04.06 CL

YTH1542XPT specifications

The Husqvarna YTH1542XPT is a versatile and powerful riding mower designed for homeowners who seek efficiency and superior performance while maintaining their lawn. This model is equipped with several innovative features and technologies that make lawn care easier and more enjoyable.

At the heart of the YTH1542XPT is a sturdy 15 horsepower Briggs & Stratton engine that delivers reliable starting and performance. The engine is paired with a hydrostatic transmission, allowing for smooth and precise speed adjustments without the need for manual gear shifting. This feature provides an easy driving experience, making it ideal for navigating around obstacles and tight spaces in your yard.

The YTH1542XPT boasts a robust 42-inch cutting deck, which is ideal for efficiently covering ground while still providing a clean and even cut. The cutting deck is designed with three different cutting heights, easily adjustable from the operator's seat, enabling users to achieve their desired grass height quickly. The air induction mowing technology also enhances grass lift, ensuring that clippings are cut evenly before being discharged – either side-discharged or mulched using an optional kit.

Furthermore, the Husqvarna YTH1542XPT features an ergonomic seat and steering wheel, ensuring comfort during extended mowing sessions. The easy-access controls allow users to engage the blades, adjust the deck height, and control speed effortlessly, all of which contribute to an enjoyable mowing experience.

In terms of build quality, the robust steel frame provides durability and stability, ensuring the lawn tractor can withstand tough terrains and conditions. The large rear wheels offer excellent traction and maneuverability on varying surfaces, while the front wheels provide an unobstructed view that makes it easier to navigate tight corners.

The YTH1542XPT also stands out with its cutting-edge technology. The compact and efficient design not only conserves space in your garage but also optimizes fuel efficiency, allowing users to mow larger areas with fewer refueling interruptions.

In summary, the Husqvarna YTH1542XPT is a reliable riding mower packed with features designed for efficiency, comfort, and ease of use. Whether tackling a small yard or a larger property, its powerful engine, adjustable cutting deck, and ergonomic controls make it an excellent choice for homeowners who value quality and performance in their lawn care tools.