Husqvarna YT180 Assemble Gauge Wheels to Mower Deck See Fig, To Convert to Bagging or Discharging

ASSEMBLY

ASSEMBLE GAUGE WHEELS TO MOWER DECK (See Fig. 7)

Assemble gauge wheels with tractor on a flat level surface.

•Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUTTING HEIGHT” in the Operation section of this manual).

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole with shoulder bolt, 17/32 washer, 3/8 washer, and 3/8-16 locknut and tighten securely.

•Repeat for opposite side installing gauge wheel in same adjustment hole.

DEFLECTOR

SHIELD

LATCH

HOOKS

FIG. 8B

GAUGE WHEEL MOUNTING BRACKET

3/8-16 LOCKNUT

3/8 WASHER

GAUGE WHEEL

17/32 WASHER

SHOULDER BOLT

CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching mulcher plate and allow it to rest on plate while in operation.

TO CONVERT TO BAGGING OR

DISCHARGING

Simply remove mulcher plate and store in a safe place. Your mower is now ready for discharging or installation of optional grass catcher accessory.

FIG. 7

INSTALL MULCHER PLATE (See Figs. 8A & 8B)

•Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown.

NOTE: Pre-assemble weld nut to latch hook by inserting weld nut from the top with hook pointing down.

•Tighten hardware securely.

•Raise and hold deflector shield in upright position.

•Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

•Hook front latch into hole on front of mower deck.

•Hook rear latch into hole on back of mower deck.

WELD NUT		HOOK
FROM THE TOP		POINTS
	LOCK	DOWN
WELD	WASHER
NUT	SCREW
LATCH
HOOK		LATCH
		HOOK
	LOCK	WELD
WASHER	WASHER	NUT

✓CHECKLIST

BEFORE YOU OPERATE AND ENJOY YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

✓All assembly instructions have been completed.

✓No remaining loose parts in carton.

✓Battery is properly prepared and charged. (Minimum 1 hour at 6 amps).

✓Seat is adjusted comfortably and tightened securely.

✓All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

✓Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

✓Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

✓Check wiring. See that all connections are still secure and wires are properly clamped.

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

✓	Engine oil is at proper level.
✓	Fuel tank is filled with fresh, clean, regular unleaded
	gasoline.

MULCHER PLATE

WASHER

✓ Become familiar with all controls - their location and

SCREW

FIG. 8A

function. Operate them before you start the engine.

✓ Be sure brake system is in safe operating condition.

9