Husqvarna YTH150 owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL FOR REPAIRS (See Fig. 29)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY

 

 

(REAR WHEEL ONLY)

 

 

 

FIG. 29

TO START ENGINE WITH A WEAK BATTERY (See Fig. 30)

CAUTION: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect each end of the RED cable to the POSITIVE

(+)terminal of each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGA- TIVE (-) terminal of fully charged battery.

Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

23

“POSITIVE” (+)

“NEGATIVE” (-)

 

L.H. PANEL

 

BOLT

FIG. 30

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 31)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedures.

HOOD

HEADLIGHT

WIRE

CONNECTOR

FIG. 31

Image 23
Contents YTH150 II. Slope Operation IV. ServiceSafe Operation Practices for Ride-On Mowers General OperationModel Number YTH150 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorTo Attach Nose Roller See Fig Install Seat See FigTo Attach Front Bumper See Fig To Convert to Bagging or Discharging Install Mulcher Plate See FigsAssemble Gauge Wheels to Mower Deck See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport See Figs Before Starting the EngineTo Operate Mower See a To Operate on HillsHydrostatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMulching Mowing Tips Mowing TipsBefore Each USE Lubrication ChartCustomer Responsibilities General RecommendationsTractor Lubrication To Service PRE-CLEANERTo Service Cartridge EngineSpark Plugs CleaningClean AIR INTAKE/COOLING Areas MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal To Adjust Brake See FigBelt Installation To Replace Mower Blade Drive Belt See FigFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Replace Fuse To Replace Headlight BulbInterlocks and Relays Acceleration Test To Adjust Throttle Control Cable See FigTo Adjust Carburetor See Fig Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsOFF Service Notes Wiring Insulated Clips SchematicIgnition Switch PTO SwitchElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Repair Parts KEY Part NO. no Description Repair Parts KEY Part Description NO. no Steering AssemblyKEY Part NO. no Description Seat AssemblyLBD48 DecalsWheels & Tires LSB42Engine KEY Part NO. NO. Description Mower Deck KEY Part Description 25 24 Mower LiftKEY Part NO. NO. Description Hydro Gear Transaxle Model Number KEY Part Description Service Notes Service Notes This OUT Dotted Lines Slope CUTLimited Warranty Warranty Statement532162559 Rev.1 03.11.98 RH/SJ