Husqvarna MZ5225ZT / 966690501, MZ6128ZT / 966613101 manual Fuel Tank, Hydro Release Levers

Page 23

CONTROLS

Fuel Tank

Read the safety instructions before refueling. The capacity for the tank is 5 gallons (19 liters).

Regularly check the gas cap gasket for damage and keep the cap properly tightened.

The engine will run on a minimum of 87-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See Technical Data concerning ethanol fuel. Methanol fuel is not allowed. Do not use E85 alcohol based fuel. Damage to the engine and components may occur.

When operating in temperatures below 32° F. (0° C.), use fresh, clean winter grade gasoline to help insure good cold weather starting.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors (see the safety instruction).

WARNING!

The engine and the exhaust system become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

Hydro Release Levers

Transaxle bypass linkages must be engaged when pushing or pulling the mower. The release levers are located on each side of the rear of the unit below the rear engine plate. See Manual Transport in the Operation section.

8065-007

Gasoline fuel tank

IMPORTANT INFORMATION

Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

8065-061

Right side, hydro release lever

23

Image 23
Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceSymbols and decals Manual Performing any General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsMotion Control Levers Model MZ5225ZT only Hour MeterChoke Control Tracking KnobParking Brake Blade SwitchIgnition Switch Fuses Fuel Shut Off Valve Cutting Height AdjusterSeat Adjustment Lever Hydro Release Levers Fuel TankSteering OperationTraining Starting the Engine Before StartingMove the throttle to the middle position Open the fuel tank valve To remove cables, reverse order Weak BatteryJumper Cables Running Ensure that no one is near mower when engaging blade switchOperating on Hills Stopping the Engine Mowing Tips Manual Transport Maintenance Maintenance Replacing battery BatteryTire Pressures Safety SystemDeck Belt Removal Deck Belt InstallationDeck Belt Replacing Pump Belt Belt InstallationPump Belt BeltsCutting Blades Leveling deck Adjusting the Mower DeckAnti-scalp rollers Hardware CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationLubrication Schedule Deck Spindles Wheel and Deck ZerksFront Wheel Mount Front Wheel BearingsTransaxle Transmission Fluid Change Purging Procedures Problem Cause Troubleshooting guideTroubleshooting guide Winter Storage ServiceStorage Engine Pigtail PUR WHT GRY MZ5225ZT MZ6128 ZT Technical DataFrame Metric Standard Hardware Torque SpecificationsHex Head Cap Screws Standard HardwareUSA requirements Conformity certificatesStamp, sign Service JournalDelivery Service ActionDate, mtr reading Stamp, sign After 10 hoursDaily Service Hour Service Service Journal Service Journal At least once each year Page 115 390127R1 08/31/10