Husqvarna MZ6128ZT / 966613101 manual Weak Battery, Jumper Cables, To remove cables, reverse order

Page 28

OPERATION

Weak Battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

The mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use the mower to start other vehicles.

IMPORTANT INFORMATION

Refer to the EFM Information Sheet from the unit literature packet for specific jump starting instructions.

If “jumper cables” are used for emergency starting,

8011-642

Jumper cable connection

follow this procedure:

 

Jumper Cables

Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

28

Image 28
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Manual Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsMotion Control Levers Hour Meter Choke ControlTracking Knob Model MZ5225ZT onlyIgnition Switch Blade SwitchParking Brake Fuses Seat Adjustment Lever Cutting Height AdjusterFuel Shut Off Valve Fuel Tank Hydro Release LeversTraining OperationSteering Before Starting Starting the EngineMove the throttle to the middle position Open the fuel tank valve Jumper Cables Weak BatteryTo remove cables, reverse order Ensure that no one is near mower when engaging blade switch RunningOperating on Hills Stopping the Engine Mowing Tips Manual Transport Maintenance Maintenance Battery Replacing batterySafety System Tire PressuresDeck Belt Deck Belt InstallationDeck Belt Removal Belt Installation Pump BeltBelts Replacing Pump BeltCutting Blades Adjusting the Mower Deck Leveling deckAnti-scalp rollers Cleaning Use protective glasses when cleaning and washingCaster Wheels HardwareLubrication Schedule LubricationGeneral Wheel and Deck Zerks Front Wheel MountFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Purging Procedures Troubleshooting guide Problem CauseTroubleshooting guide Storage ServiceWinter Storage Engine Pigtail PUR WHT GRY Technical Data MZ5225ZT MZ6128 ZTFrame Torque Specifications Hex Head Cap ScrewsStandard Hardware Metric Standard HardwareConformity certificates USA requirementsService Journal Delivery ServiceAction Stamp, signAfter 10 hours Date, mtr reading Stamp, signDaily Service Hour Service Service Journal Service Journal At least once each year Page 115 390127R1 08/31/10