Husqvarna 2748 GLS (CA) manual To Install Mower See Figs, First Install ANTI-SWAY BAR S

Page 20

SERVICE AND ADJUSTMENTS

From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

Turn tractor steering wheel to the left as far as it will go.

Slide mower out from under right side of tractor.

TO INSTALL MOWER (See Figs. 18-24)

Be sure tractor is on level surface and engage parking brake.

Lower attachment lift lever to its lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right.

02965

A

02965

NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor.

Slide mower under tractor until it is centered under tractor.

FIRST INSTALL ANTI-SWAY BAR (S).

-From right side of mower, insert anti-sway bar into hole in transmission bracket (T).

T

S

 

A

 

 

02995

FIG. 18

-Pivot bar towards you and insert other end of bar into hole in rear mower bracket (D). Move mower as needed to insert bar.

D

02996

FIG. 19

-Secure with washer and retainer spring as shown

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring.

A

B

19

FIG. 20

 

Image 20
Contents GLS CA Page Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Assembly Tools Required for AssemblyUnassembled Parts To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineReverse Operation System ROS To Operate on HillsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips General Recommendations MaintenanceLubrication Chart Battery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Remove Mower See FigTo Install Mower See Figs First Install ANTI-SWAY BAR SEngage belt tension rod K on locking bracket L To Level Mower Turn nut right Turn nut left To raise mowerMower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderWire To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Schematic Tractor Model no GLS 96043005000, Product no 43Tractor Model no GLS 96043005000, Product no 43 Electrical KEY Part DescriptionChassis Tractor Model no GLS 96043005000, Product no 43 Drive Tractor Model no GLS 96043005000, Product no 43 Steering Assembly Engine Spark Arrester KITSeat Assembly Decals Wheels and TiresMower Deck Tractor Model no GLS 96043005000, Product no 43 Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 88-49 Rev 1 03-31-08 SBW/TH Warranty Statement