Husqvarna 2748 GLS (CA) manual Engage belt tension rod K on locking bracket L

Page 21

SERVICE AND ADJUSTMENTS

•Repeat on opposite side of tractor.

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin on rear mower bracket (D) and secure with washer and retainer spring.

C

D

FIG. 21

•Repeat on opposite side of tractor.

•Turn steering wheel to position wheels straight for- ward.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F) and secure with retainer spring (G) through hole in link located behind the bracket.

•Insert other end of link (E) into hole in front mower bracket

(H) and secure with washer and retainer spring (J).

EH J

F

G

FIG. 22

•Disengage belt tension rod (K) from locking bracket (L).

•Install belt onto engine clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

M

FIG. 23

•Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

B M

LF

KA

H E

S

C

D

FIG. 24

20

Image 21

Contents GLS CA Page Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To Operate MowerBefore Starting the Engine Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsTo Start Engine See Fig ADD GasolinePurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance Lubrication ChartGeneral Recommendations Tractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Remove Mower See Fig Service and AdjustmentsFirst Install ANTI-SWAY BAR S To Install Mower See FigsEngage belt tension rod K on locking bracket L Turn nut right Turn nut left To raise mower To Level MowerMower Drive Belt Installation To Replace Mower Blade Drive Belt See FigMower Drive Belt Removal To Check Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTo Adjust Throttle Control Cable WireTo Adjust Choke Control To Adjust CarburetorOther StorageFuel System Engine OILTroubleshooting Points Engine dies when Tractor Model no GLS 96043005000, Product no 43 SchematicTractor Model no GLS 96043005000, Product no 43 KEY Part Description ElectricalChassis Tractor Model no GLS 96043005000, Product no 43 Drive Tractor Model no GLS 96043005000, Product no 43 Steering Assembly Spark Arrester KIT EngineSeat Assembly Wheels and Tires DecalsMower Deck Tractor Model no GLS 96043005000, Product no 43 Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 41 88-49 Rev 1 03-31-08 SBW/TH Warranty Statement