Husqvarna 532 44 02-80 HOW to USE Your Tractor, To SET Parking BRAKESee Fig, Stopping See Fig

Page 12

OPERATION

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE(See Fig. 16)

Your tractor is equipped with an operator presence sens- ing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

Depress brake pedal (B) all the way down and hold.

Pull parking brake lever (C) up and hold, release pres- sure from brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

C

B

Fig. 16

STOPPING (See Fig. 17)

MOWER BLADES -

To stop mower blades, place attachment clutch control in the “DISENGAGED” position ().

 

 

 

 

(

 

) ATTACHMENT

( ) ATTACHMENT

 

 

 

 

CLUTCH SWITCH

CLUTCH SWITCH

 

 

“DISENGAGED”

“ENGAGED”

 

 

 

 

Fig. 17

GROUND DRIVE -

To stop ground drive, depress brake pedal all the way down.

Move motion control lever (J) to neutral position.

ENGINE -

Move throttle control (D) between half and full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) position, before stopping, may cause engine to “backfire”.

Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

Never use the choke to stop the engine.

IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO DISCHARGE AND GO DEAD.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, al- ways stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, and set parking brake before leaving the opera- tor's position.

TO USE THROTTLE CONTROL (D) (See Fig. 18)

Always operate engine at full speed (fast).

Operating engine at less than full speed (fast) reduces the engine's operating efficiency.

Full speed (fast) offers the best mower performance.

D

N

F

Fig. 18

TO USE CHOKE CONTROL (N) (See Fig. 18)

Use choke control whenever you are starting a cold engine. Do not use to start a warm engine.

To engage choke control (N), pull knob out. Slowly push knob in to disengage.

12

Image 12
Contents LGT2554 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts SkidAdjust Seat See Fig To Install Mower and Drive Belt See FigsSET Parking Brake Lever and Lower AT- Tachment Lift See Fig Install ANTI-SWAY BAR S if Equipped See Turn Steering Wheel Left and Position Mower See FigANTI-SWAY BAR S Attach Mower Side Suspension Arms a to Chassis See Fig Attach Rear Lift Links C See FigAttach Front Link E See Fig Install Belt on Engine Clutch Pulley M See Check Tire PressureCheck Deck Levelness CheckforproperpositionofallbeltsOperation Know Your Tractor DPH AC JHOW to USE Your Tractor To SET Parking BRAKESee FigStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To Operate MowerService REMINDER/HOUR Meter Reverse Operation System ROSTo Operate on Hills To Transport SeeBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigTo Level Mower To Replace Motion Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTransmission Storage OtherFuel System Engine OILProblem Cause Correction To run when oper Battery will notFires when turn Engine continuesSchematic Tractor Model NO. LGT2554 96045003100, Product no 45Electrical KEY Part Description Chassis Tractor Model NO. LGT2554 96045003100, Product no 45 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Engine 30!2+ª!22%34%2ª+4Seat Assembly 532 42 SeatSteering Assembly 532 41 Wheel, Steering 532 19 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Decals Wheels and TiresSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart 11.10.10 JA