Husqvarna LTH2038 manual Table of Contents

Page 4

PRODUCT SPECIFICATIONS

GASOLINE CAPACITY

1.5 GALLONS

 

AND TYPE:

UNLEADED REGULAR

 

 

OIL TYPE (API: SF-SJ):

SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

 

 

 

OIL CAPACITY:

W/ FILTER:

56 Oz.

 

W/O FILTER:

48 Oz.

 

 

SPARK PLUG:

Champion (RC12YC)

 

(GAP: .030")

 

 

 

GROUND SPEED (MPH): FORWARD:

0 - 5.2

 

REVERSE:

0 - 2.9

 

 

CHARGING SYSTEM:

3 AMPS BATTERY

 

5 AMPS HEADLIGHT

 

 

 

BATTERY:

AMP/HR:

28

 

MIN. CCA:

230

 

CASE SIZE:

U1R

 

 

 

BLADE BOLT TORQUE:

45-55 FT. LBS.

 

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center/department. We have competent, well-trained techni- cians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tractor.

Follow the instructions under “Maintenance” and “Stor- age” sections of this manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any un- improved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service center/department.

TABLE OF CONTENTS

SAFETY RULES

2-3

PRODUCT SPECIFICATIONS

4

CUSTOMER RESPONSIBILITIES

4

ASSEMBLY

5-7

OPERATION

8-14

MAINTENANCE SCHEDULE

15

MAINTENANCE

15-18

SERVICE AND ADJUSTMENTS

19-24

STORAGE

25

TROUBLESHOOTING

26-27

4

Image 4
Contents LTH2038 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts To Remove Tractor from CartonTo Install Steering Wheel See Fig Install Seat See FigsTo Adjust Seat See Fig Assemble Extension Shaft and BootTo Install Hood Scoop See Fig Check Tire PressureCheck Deck Levelness Check Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigTo USE Throttle Control D See Fig Stopping See FigService REMINDER/HOUR Meter To Operate MowerTo Stop Mower Blades To Operate on HillsBefore Starting the Engine Reverse Operation System ROSTo Transport See Fig Check Engine OIL LevelPurge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning Spark PlugsIN-LINE Fuel Filter See Fig Deck Washout Port See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Belt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check BrakeTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove Wheel See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionEngine continues Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX06.21.10 CL