Husqvarna LTH1536 owner manual Table of Contents

Page 4

PRODUCT SPECIFICATIONS

GASOLINE CAPACITY

1.25 GALLONS

AND TYPE:

UNLEADED REGULAR

 

 

OIL TYPE (API-SF-SJ):

SAE 10W-30 (above 32°F)

 

SAE 5W-30 (below 32°F)

OIL CAPACITY:

3.0 PINTS

 

 

 

SPARK PLUG:

CHAMPION RC12YC

(GAP: .030")

 

 

 

 

 

GROUND SPEED (MPH):

Forward:

0-5.2

 

Reverse

0-2.7

TIRE PRESSURE:

FRONT:

14 PSI

 

REAR:

12 PSI

CHARGING SYSTEM:

15 Amps @ 3600 RPM

 

 

 

BATTERY:

AMP/HR:

35

 

MIN. CCA:

280

 

CASE SIZE:

U1R

BLADE BOLT TORQUE:

27–35 FT. LBS.

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the "SAFETY RULES".

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tractor.

Follow the instructions under the "Maintenance" and "Storage" sections of this owner's manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service center/department (See REPAIR PARTS section of this manual).

TABLE OF CONTENTS

SAFETY RULES

2-3

PRODUCT SPECIFICATIONS

4

CUSTOMER RESPONSIBILITIES

4

ASSEMBLY

6-8

OPERATION

9-14

MAINTENANCE SCHEDULE

15

MAINTENANCE

15-18

SERVICE AND ADJUSTMENTS

19-23

STORAGE

24

TROUBLESHOOTING

25-26

REPAIR PARTS - TRACTOR

28-43

4

Image 4
Contents LTH1536 Safety Rules IV. ServiceGeneral Operation II. Slope OperationSafety Rules Table of Contents Unassembled Parts Steering Wheel SeatKey Slope SheetAssembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonConnect Battery See Figs a and 3B Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting Height See Fig Stopping See FigTo SET Parking Brake See Fig To USE Throttle Control See FigBefore Starting the Engine To Operate Mower See FigTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance Lubrication ChartGeneral Recommendations Before Each USETractor Engine Cleaning AIR FilterEngine OIL Filter MufflerTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Level Mower Housing To Replace Mower Blade Drive Belt See FigTo Check and Adjust Brake See Fig To Replace Motion Drive Belt See FigTransmission REMOVAL/REPLACEMENT Transaxle Motion Control Lever Neutral ADJUSTMENTSee FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points With attachment clutch Schematic Tractor Model NO. LTH1536 HAU15HK36B, Product no 17Electrical KEY Part NO. NO. Description Chassis and Enclosures 532 19 18-14 Dash P/L Drive KEY Part Description CRDSteering Assembly KEY Part NO. NO. Description Engine Repair Parts Seat Assembly Decals Wheels & TiresMower Deck Repair Parts Mower Lift Repair Parts Service Notes Service Notes Warranty Statement Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 19 20-12 03.05.04 TR