Husqvarna LTH140 owner manual Storage, Other

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Customer Responsibilities section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Customer Responsibilities section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Cus- tomer Responsibilities section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

Be sure battery drain tube is securely attached.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Customer Responsibilities section of this manual).

CYLINDERS

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Image 26
Contents LT H 1 4 Safety Rules Safe Operation Practices for Ride-On MowersModel Number LTH140 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly Before Rolling Tractor OFF SkidCheck Deck Levelness HOW to SET UP Your TractorCheck Tire Pressure Check for Proper Position of ALL BeltsInstall Battery See Figs To Attach Front Bumper See FigAssemble Gauge Wheels to Mower Deck See Fig To Convert to Bagging or DischargingOperation Know Your TractorHOW to USE Your Tractor ADD Gasoline Before Starting the EngineTo Operate on Hills Purge Transmission Mowing TipsTo Start Engine See Fig Customer Responsibilities Lubrication ChartService Dates General RecommendationsTires TractorBrake Operation Blade CareBelts Battery See FigTo Clean Battery and Terminals Transaxle CoolingEngine To Service PRE-CLEANERTo Service Cartridge LubricationMuffler CleaningClean AIR INTAKE/COOLING Areas Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsBelt Installation To Adjust Attachment Clutch See FigTo Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Adjust Motion Control Lever See FigTransmission REMOVAL/REPLACEMENT Front Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig To Remove Wheel for Repairs See FigTo Replace Fuse To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig To Replace Headlight BulbFinal Setting To Adjust Carburetor See FigPreliminary Setting Acceleration TestStorage OtherTroubleshooting Points Problem Cause CorrectionOFF Schematic 14 HP 42 Tractor Model NO. LTH140 954001192AElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part NO. no Description Drive KEY Part Description Engine 532132753 Control Th/ch Steering Assembly Repair Parts Seat Assembly 14 HP 42 Tractor Model NO. LTH140 H954001192ALSB42 DecalsLBD48 Mower KEY Part NO. no Description Mower Lift Assembly Repair Parts HYDRO-GEAR Transaxle Model no Repair Parts Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideWarranty Statement Limited Warranty