Husqvarna LTH130 owner manual Install Seat See Fig, To Attach Front Bumper See Fig

ASSEMBLY

Open battery box door for:

•Inspection for secure connections (to tighten hard- ware).

•Inspection for corrosion.

•Testing battery.

•Jumping (if required).

•Periodic charging .

	DISCARD
POSITIVE	TERMINAL
	PROTECTIVE
(RED) CABLE	CAPS
	HEX	LOCK
		WASHER
	NUT
		FLAT
		WASHER
		HEX
		BOLT
	NEGATIVE
	(BLACK) CABLE

FIG. 2

SEAT

PAN

BATTERY

BOX DOOR

FIG. 3

INSTALL SEAT (See Fig. 4)

Adjust seat before tightening adjustment knob.

•Remove cardboard packing on seat pan.

•Place seat on seat pan and assemble shoulder bolt. Tighten shoulder bolt securely.

•Assemble adjustment knob and flat washer loosely. Do not tighten.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

SEAT

SEAT PAN

SHOULDER

BOLT

ADJUSTMENT	LARGE FLAT WASHER
KNOB

FIG. 4

TO ATTACH FRONT BUMPER (See Fig. 5)

NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting bumper to tractor.

•Press or tap the end caps into ends of bumper tube.

•The existing top screw and the existing front screw must be removed from both sides.

•On both sides of chassis, position extension bracket as shown and loosely assemble to rear chassis hole with supplied 3/8-16 x 1-1/4 screw. Do not tighten the brackets. Allow them to hang from the chassis.

•Position bumper and extension brackets so brackets can be slid inside flattened ends of bumper.

•Slide bumper onto brackets and pivot upwards to align center holes in extension brackets and tractor chassis.

•With holes aligned, install additional screws.

•Tighten all four (4) screws securely.

FRONT	TOP
	SCREW
SUSPENSION
BRACKET
	BUMPER
	EXTENSION
	BRACKET
	END CAP
	Slide Bumper onto
	Extension Brackets
	and Pivot Upwards
	FRONT SCREW

FIG. 5

7