Husqvarna LTH130 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 20

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key “OFF” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 21)

Mower will be easier to remove from the right side of tractor.

•Place attachment clutch switch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off electric clutch pulley.

•Disconnect anti-sway bar from chassis bracket by removing retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER (See Fig. 22)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with discharge guard to right side of tractor.

•Lower lift lever to its lowest position.

•Install mower in reverse order of removal instructions.

SUSPENSION

ELECTRIC

 

ARMS

CLUTCH

FRONT

 

PULLEY

 

 

LINK

 

 

RETAINER

 

 

SPRINGS

 

 

(BOTH SIDES)

RETAINER

 

 

SPRING

 

 

ANTI-SWAY BAR

RETAINER

 

 

 

 

SPRINGS

 

 

(BOTH SIDES)

 

FIG. 21

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” on page 3 of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 22 and 23)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

BOTTOM EDGE

OF MOWER TO

OF MOWER TO

GROUND

GROUND

A

A

 

GROUND LINE

FIG. 22

SUSPENSION ARM

LIFT LINK

ADJUSTMENT NUT

FIG. 23

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents LTH130 IV. Service Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationModel Number LTH130 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig To Attach Front Bumper See FigAssemble Gauge Wheels and BRACK- ETS to Mower Deck See Fig Install Mulcher Plate See FigsTo Attach Nose Roller See Fig To Convert to Bagging or Discharging Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine Check Engine OIL Level See FigTo Operate on Hills ADD GasolineHydrostatic Transmission Warm UP To Start Engine See FigPurge Transmission Mowing Tips Mulching Mowing TipsLubrication Chart Customer ResponsibilitiesGeneral Recommendations Before Each USETractor To Service PRE-CLEANER To Service CartridgeEngine LubricationCleaning Clean AIR INTAKE/COOLING AreasMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigTo Adjust Brake See a Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment To Replace Fuse To Replace Headlight BulbInterlocks and Relays Acceleration Test To Adjust Throttle Control Cable See FigTo Adjust Carburetor See Fig Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionOFF Service Notes Schematic Ignition SwitchPTO Switch Wiring Insulated ClipsElectrical KEY Part NO. NO. Description Chassis and Enclosures Repair Parts Drive KEY Part NO. no Description Repair Parts Steering Assembly KEY Part Description NO. noSeat Assembly Decals Wheels & TiresKEY Part Description LSB42Engine KEY Part NO. NO. Description Mower Deck KEY Part Description Mower Lift Repair Parts Hydro Gear Transaxle Model Number Repair Parts Page Page CUT This OUT Dotted Is a SlopeWarranty Statement Limited Warranty532162073 10.28.97 RH
Top Page Image Contents