Husqvarna LTH1742TWIN Before Starting the Engine, To Transport See Figs, Check Engine OIL Level

Page 13

OPERATION

TO TRANSPORT (See Figs. 4 and 9)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

02219

FIG. 9

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Pull up and remove oil fill cap/dipstick; wipe oil off. Re- insert the dipstick into the tube and push down firmly into place. Remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or

 

fuel. Do not store, spill or use gasoline

 

near an open flame.

13

 

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel sys- tem of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to fast position

Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

Image 13
Contents LTH1742TWIN Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See a Install Seat See Figs a and 2bAttach Hood Scoop See b Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To Move Forward and Backward HOW to USE Your TractorUsing the Reverse Operation System To Adjust Mower Cutting Height See FigTo Operate Mower See Fig Reverse Operation System ROS See FigTo Transport See Figs Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP Lubrication Chart MaintenanceService Dates General RecommendationsBlade Care TractorBlade Removal see a To Sharpen Blade See BEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig On rear mower bracket and secure with washer Retainer spring To Level Mower To Replace Mower Blade Drive Belt See Fig Belt InstallationTo Replace Motion Drive BELTSee FIG To Check BrakeTo Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points With attachment clutch Service Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 41 73-88 11.02.07 AP

LTH1742TWIN specifications

The Husqvarna LTH1742TWIN is a standout in the realm of garden tractors, designed to deliver exceptional performance for home gardeners and those with larger yards. This versatile machine offers a perfect combination of power, efficiency, and ease of use, making it an ideal choice for a variety of mowing tasks.

At the heart of the LTH1742TWIN is its robust 17-horsepower Briggs & Stratton twin-cylinder engine, which provides ample power for tackling even the thickest grass. The engine is both reliable and efficient, ensuring that users can complete their mowing tasks with minimal downtime. Additionally, the hydrostatic transmission enhances the driving experience, offering smooth and effortless speed adjustments with the simple push of a pedal. This feature allows users to easily navigate around obstacles without the need for frequent gear changes.

One of the standout features of the LTH1742TWIN is its 42-inch cutting deck, designed with a clear-cutting edge to ensure a tidy and professional-looking finish. The deck is equipped with two blades that effectively slice through grass and other vegetation, providing a superior cut that promotes a healthier lawn. Furthermore, the deck can be easily adjusted to cut at different heights, allowing users to customize their mowing heights based on their preferences and the condition of their lawn.

In terms of design, the Husqvarna LTH1742TWIN includes an ergonomic steering wheel and comfortable seat, ensuring that operators can mow for extended periods without discomfort. The cutting deck has a washout port, making it easy to clean after use and maintain the mower in optimal condition. Additionally, the rugged chassis and durable construction are built to endure the rigors of regular use in various lawn care environments.

Technologically, the Husqvarna LTH1742TWIN features an intuitive control panel that provides quick access to essential functions, including blade engagement and throttle control. This thoughtful design enhances user control and ensures a more efficient mowing experience. The option for mulch, bag, or side-discharge options further adds to its versatility, allowing users to choose how they want to handle grass clippings.

In summary, the Husqvarna LTH1742TWIN is a powerful and user-friendly garden tractor designed to meet the needs of homeowners. With its effective twin-cylinder engine, versatile cutting deck, and ergonomic design, this lawn mower is not just an investment; it is a valuable partner in maintaining a beautiful and healthy lawn.