Husqvarna LOYTH20F42T manual To Operate Mower, Reverse Operation System ROS, To Operate on Hills

Page 12

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equip- ment on rough, rolling terrain or hills.

1.Select desired height of cut with at- tachment lift lever.

2.Start mower blades by engaging at-

tachment clutch control.

TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield (S) in place.

S

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direc- tion with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the at- tachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

1.Depress brake pedal all the way down.

2.With engine running, turn ignition key counterclockwise to ROS "ON" posi- tion.

3.Look down and behind before and while backing.

4.Slowly depress reverse drive pedal to start movement.

5.When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

ROS "ON" Position

Engine "ON" Position

 

(Normal Operating)

02828

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. Use the slope guide provided at the back of this manual.

Choose the slowest speed before start- ing up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

To restart movement, slowly release parking brake and brake pedal.

Slowly depress appropriate drive pedal to slowest setting.

Make all turns slowly.

TO TRANSPORT

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Freewheel control is located at the rear drawbar of tractor.

1.Raise attachment lift lever to its highest position.

2.Pull freewheel control out and into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To re-engage transmission, reverse above procedure.

Transmission Engaged

02219

Transmission Disengaged

12

Image 12
Contents LOYTH20F42T Safety Rules General OperationService II. Slope OperationIII. Children IV. TowingGeneral Service Table of Contents ASSEMBLY/PRE-OPERATION Unassembled PartsTo Remove Tractor from Carton Checklist Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Attachment Clutch Switch Service Reminder / Hour MeterKnow Your Tractor THROTTLE/CHOKE ControlHOW to USE Your Tractor To SET Parking BrakeStopping To USE Throttle Control DSystem Characteristics To Move Forward BackwardTo USE Cruise Control Using the Reverse Operation System To Operate MowerReverse Operation System ROS To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelTo Start Engine Purge TransmissionMowing Tips Maintenance Lubrication ChartTractor Transaxle Pump Fluid EngineTransaxle Cooling BeltsCleaning Service and Adjustments To Install MowerTractor To Remove Mower Page Visual SIDE-TO-SIDE Adjustment Precision SIDE-TO-SIDE AdjustmentTo Level Mower To Adjust Attachment Clutch To Replace Mower Drive BeltTo Replace Motion Drive Belt Belt Installation To Check BrakeTo Remove Wheel for Repairs Replacing Battery To Start Engine with a Weak BAT- TeryTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust CarburetorTo Remove Hood and Grill AS- Sembly Battery StorageOther Troubleshooting Chart Problem Cause CorrectionExcessive Mower blades will Warranty Limited WarrantySuggested Guide for Sighting Slopes for Safe Operation