Husqvarna LOYTH20F42T manual Service and Adjustments, Tractor To Remove Mower, To Install Mower

Page 20

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER- VICE OR ADJUSTMENTS:

1.Depress brake pedal fully and set parking brake.

2.Place attachment clutch in “DISENGAGED” position.

3.Turn ignition key to “STOP” and remove key.

4.Make sure the blades and all moving parts have completely stopped.

5.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER

1.Place attachment clutch in “DISEN- GAGED” position.

2.Lower attachment lift lever to its lowest position.

3.Remove mower belt from electric clutch pulley (M).

4.Disconnect front link (E) from mower - remove retainer spring and washer.

5.Go to either side of mower and discon- nect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

6.Go to other side of mower and discon- nect the suspension arm and rear lift link.

CAUTION: After rear lift links are dis- connected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

7.Slide mower out from under right side of tractor.

TO INSTALL MOWER

Be sure tractor is on level surface and engage parking brake.

1.Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

NOTE: Be sure mower side suspension arms (A) are pointing forward before slid- ing mower under tractor.

2.Slide mower under tractor until it is centered under tractor.

3.ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring.

4.Repeat on opposite side of tractor.

BMF

A E

H

C

D

20

Image 20
Contents LOYTH20F42T Safety Rules General OperationService II. Slope OperationIII. Children IV. TowingGeneral Service Table of Contents To Remove Tractor from Carton ASSEMBLY/PRE-OPERATIONUnassembled Parts Checklist Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Attachment Clutch Switch Service Reminder / Hour MeterKnow Your Tractor THROTTLE/CHOKE ControlHOW to USE Your Tractor To SET Parking BrakeStopping To USE Throttle Control DTo USE Cruise Control System CharacteristicsTo Move Forward Backward Using the Reverse Operation System To Operate MowerReverse Operation System ROS To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelTo Start Engine Purge TransmissionMowing Tips Maintenance Lubrication ChartTractor Transaxle Pump Fluid EngineTransaxle Cooling BeltsCleaning Tractor To Remove Mower Service and AdjustmentsTo Install Mower Page To Level Mower Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment To Replace Motion Drive Belt To Adjust Attachment ClutchTo Replace Mower Drive Belt To Remove Wheel for Repairs Belt InstallationTo Check Brake Replacing Battery To Start Engine with a Weak BAT- TeryTo Replace Headlight Bulb Interlocks and RelaysTo Remove Hood and Grill AS- Sembly To Adjust Throttle Control CableTo Adjust Carburetor Other BatteryStorage Troubleshooting Chart Problem Cause CorrectionExcessive Mower blades will Warranty Limited WarrantySuggested Guide for Sighting Slopes for Safe Operation