TO START ENGINE
When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.
1.Be sure freewheel control is in the transmission engaged position.
2.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.
3.Place motion control lever in neutral
(N) position.
4.Move attachment clutch to disengaged position.
5.Move throttle control to fast position
6.Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be
needed.
NOTE: Before starting, read the warm and cold starting procedures below.
7.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do
not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke con- trol out and retry.
WARM WEATHER STARTING (50° F and above)
8.When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then
continue to push the control in slowly.
•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.
COLD WEATHER STARTING (50° F and below)
8.When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the en- gine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine
AUTOMATIC TRANSMISSION WARM UP Before driving the unit in cold weather, the transmission should be warmed up as follows:
1.Be sure the tractor is on level ground.
2.Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.
3.Allow one minute for transmission to warm up. This can be done during the
engine warm up period.
•The attachments can be used during the engine
may require the choke control be pulled out slightly.
NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance (see “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual).
PURGE TRANSMISSION
CAUTION: Never engage or dis- engage freewheel lever while the engine is running.
To ensure proper operation and per- formance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the trans- mission which may have developed during shipping of your tractor.
IMPORTANT: Should your transmission require removal for service or replace- ment, it should be purged after reinstall- ation before operating the tractor.
1.Place tractor safely on a level surface
- that is clear of objects and open - with engine off and parking brake set.
2.Disengage transmission by placing freewheel control in disengaged posi- tion (See “TO TRANSPORT” in this section of manual).
3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly disengage clutch/brake
pedal.
CAUTION: At any time, during step 4, there may be movement of the drive wheels.
14