Husqvarna HU800BBC manual Drive Control See Fig, Drive Control Adjustment See Fig

Page 7

OPERATION

DRIVE CONTROL (See Fig. 6)

•Self-propelling is controlled by holding the operator presence control bar down to the handle and pulling either drive control lever rearward to the handle. The further toward the handle a lever is pulled, the faster the unit will travel.

•To stop forward motion without stopping blade, release a drive control lever. Hold operator presence control bar down against handle to continue mowing without self-propelling.

NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels.

OPERATOR

PRESENCE

CONTROL BAR

TO ENGAGE DRIVE CONTROL

DRIVE

CONTROL

LEVERS

DRIVE CONTROL DISENGAGED

FIG. 6

DRIVE CONTROL ADJUSTMENT (See Fig. 7)

Over time, the drive control system may become “loose”, resulting in decreased speed. There is a turnbuckle on the drive control housing to increase tension on the drive cable. Proceed as follows:

1.Turn unit off and disconnect spark plug wire from spark plug.

2.Rotate turnbuckle on drive control to increase drive speed.

3.Operate mower to test drive speed. Readjust as re- quired.

NOTE: If condition fails to improve after the above steps (forward speed remains the same), your drive belt is worn and should be replaced.

ADJUSTMENT

TURNBUCKLE

FIG. 7

TO ADJUST CUTTING HEIGHT (See Fig. 8)

All four wheels are adjusted by a single lever.

•Pull adjuster lever toward wheel. To raise mower, move lever forward to desired position. To lower mower, move the lever toward the rear.

WHEEL

ADJUSTER

LEVER

LEVER BACKWARD

TO LOWER MOWER

LEVER FORWARD

TO RAISE MOWER

FIG. 8

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents HU800BBC III. Children Safe Operation Practices for Walk-Behind MowersII. Slope Operation General OperationTable of Contents To Remove Lawn Mower from Carton AssemblyHOW to SET UP Your Lawn Mower To Install AttachmentsOperation Meets Cpsc Safety RequirementsKnow Your Lawn Mower Engine Zone Control HOW to USE Your Lawn MowerThrottle / Engine Control See Fig Blade Control See FigTo Adjust Cutting Height See Fig Drive Control Adjustment See FigDrive Control See Fig ADD OIL See Fig Before Starting EngineTo Convert Mower To Empty Grass Catcher See FigADD Gasoline See Fig To Stop Engine See FigMulching Mowing Tips Mowing TipsBefore Each USE MaintenanceLubrication Chart General RecommendationsGrass Catcher Lawn MowerTires Drive WheelsTo Change Engine OIL See Figs EngineAIR Filter See Fig Spark Plug CleaningWater Washout Feature See Fig MufflerStorage Service and AdjustmentsEngine OIL OtherHandle See Figs Fuel SystemProblem Cause Correction Troubleshooting PointsLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Qjlqh 7UDQVPLVVLRQ Service Notes
Top Page Image Contents