Husqvarna GTH26V48LS owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTSSUCHASCARBURETOR, FUELFILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents GTH26V48LS Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Attachment Clutch Switch Disengaged Engaged HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Using the Reverse Operation SystemReverse Operation System ROS See Fig To Operate on HillsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig O PRaise attachment lift lever to highest position To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig Belt InstallationFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Fig To Start Engine with a Weak Battery see FIGTo Remove CABLES, Reverse Order Transmission Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine continues Wheels and Tires DecalsKEY Part Description KEY Part NO. NO. DescriptionSCH12 SchematicElectrical KEY Part Description Chassis Tractor Model NO. GTH26V48LS 96043009000, Product no 43 Drive G7-BCBB-1XDC-1FCA Engine Engine Power Rating Information Steering Assembly Tractor Model NO. GTH26V48LS 96043009000, Product no 43 Seat Assembly    Mower LiftMower Deck Tractor Model NO. GTH26V48LS 96043009000, Product no 43 Service Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation12.15.09 BAD

GTH26V48LS specifications

Husqvarna GTH26V48LS is a powerful and reliable lawn tractor designed for homeowners looking for efficiency and comfort in lawn care. With its robust engine and advanced features, it aims to make the mowing experience smoother and more enjoyable.

One of the standout characteristics of the GTH26V48LS is its 26 HP Kohler engine, which provides ample power for cutting through tough grass and tackling uneven terrains. The engine is designed to deliver both power and fuel efficiency, ensuring that homeowners can tend to their lawns without frequently worrying about refueling.

The cutting deck of the Husqvarna GTH26V48LS is 48 inches wide, allowing for a wider cutting path and efficient mowing of larger areas. This deck is equipped with three blades that provide a clean and precise cut, coupled with an adjustable cutting height ranging from 1 to 4 inches. Users can easily customize their mowing height to suit the grass type and personal preference.

Another significant feature is the pedal-operated hydrostatic transmission, which offers an easy and smooth driving experience. This system allows for effortless speed control without the need for shifting gears, making it an excellent choice for those who may be less experienced with lawn tractors. Coupled with the ergonomic steering wheel, the overall operation is designed for comfort during prolonged mowing sessions.

The Husqvarna GTH26V48LS also incorporates advanced technologies such as the SmartSwitch electrical control system, which simplifies starting and operation. This technology ensures a reliable starting process while minimizing potential issues down the line.

Additionally, the tractor features a comfortable high-back seat that provides support during longer mowing sessions. The front headlights enhance visibility while mowing in low light conditions, making it practical for early morning or late evening tasks.

Overall, the Husqvarna GTH26V48LS combines power, efficiency, and comfort, making it an ideal choice for homeowners seeking a robust lawn tractor that can handle various lawn care needs.
Top Page Image Contents