Husqvarna GTH2648 owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Image 24
Contents GTH2648 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Operate Mower Reverse Operation System ROSService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Brake OperationEngine Cleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigsTo Remove Mower See Fig To Level Mower Turn nut right Turn nut left To raise mower Mower Drive Belt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Mower Drive Belt RemovalTo Start Engine with a Weak Battery See Fig Belt InstallationFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor Model NO. GTH2648 96043003000, Product no 43Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive Transaxle, Hydro Engine Engine Power Rating Information Seat Assembly Decals Wheels and TiresMower Deck Tractor Model NO. GTH2648 96043003000, Product no 43 Mower Lift Steering Assembly Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement 532 40 83-75 12.1.06 CL

GTH2648 specifications

The Husqvarna GTH2648 is a robust and reliable garden tractor that offers exceptional performance for homeowners looking to maintain their lawns and gardens with ease. This machine is designed to provide a smooth and comfortable mowing experience, making it a popular choice among enthusiasts and professionals alike.

One of the standout features of the GTH2648 is its powerful engine. Driven by a 24-horsepower Briggs & Stratton engine, this tractor delivers the reliability and performance needed for tackling various mowing tasks. The engine is designed for easy starting and low maintenance, offering a dependable performance season after season.

The GTH2648 is equipped with a 48-inch cutting deck, which allows for efficient mowing of large and medium-sized lawns. The deck features a triple blade system that ensures an even cut for improved lawn health. Additionally, the cutting height can be easily adjusted with the help of a simple lever, providing users with the flexibility to choose the perfect length for their grass.

Another key aspect of the Husqvarna GTH2648 is its user-friendly controls. The ergonomically designed steering wheel and comfortable seat offer a pleasant driving experience, while the pedal-operated hydrostatic transmission allows for seamless forward and reverse movement. This feature makes it easy to maneuver around obstacles and navigate tight spaces, enhancing the overall efficiency of the mowing process.

The GTH2648 also boasts advanced safety features. Its automatic blade engagement system allows the blades to be engaged and disengaged with ease, minimizing the risk of accidents. Moreover, the tractor's robust construction ensures stability and durability, allowing users to tackle various terrains without fear of damaging the machine.

For added convenience, the Husqvarna GTH2648 comes with optional attachments, such as a bagging system and a mulching kit. These accessories enable users to customize their mowing experience further and provide additional functionality throughout the year, such as leaf collection and lawn fertilization.

In summary, the Husqvarna GTH2648 is an all-around garden tractor that combines power, efficiency, and user-friendly features. With its durable construction and innovative technologies, this tractor is an excellent investment for anyone looking to enhance their lawn care routine. Whether you are mowing, bagging, or mulching, the GTH2648 delivers performance and reliability to meet all your gardening needs.