Husqvarna GTH225 owner manual To Operate Mower See Fig, To Operate on Hills, To Transport See Figs

Page 14

OPERATION

•Be sure tractor is on a flat level surface.

•Lower mower and adjust mower to desired cutting height.

•Remove retainer spring and clevis pin which secure each gauge wheel bar.

•Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should be slightly off the ground.

•Replace retainer spring into clevis pin.

IMPORTANT: BE SURE TO READJUST GAUGE WHEELS IF YOU CHANGE THE CUTTING HEIGHT OF THE MOWER DECK.

RETAINER

SPRING

CLEVIS

PIN

FIG. 12

TO OPERATE MOWER (See Fig. 13)

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

•Select desired height of cut.

•Lower mower with attachment lift control.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the dis- charge guard in place.

ATTACHMENT CLUTCH

LIFT LEVER

SWITCH PULL OUT TO

HIGHEST

“ENGAGE”

POSITION

 

LOWEST

 

POSITION

PUSH IN TO “DISENGAGE”

DISCHARGE

GUARD

FIG. 13

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move motion control lever to neutral (N) position.

IMPORTANT: THE MOTION CONTROL LEVER DOES NOT RETURN TO NEUTRAL (N) POSITION WHEN THE CLUTCH/BRAKE PEDAL IS DEPRESSED.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Slowly move motion control lever to slowest setting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 10 and 14)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Remove retainer spring from freewheel control rod.

•Push control rod in to disengage transmission and reinsert retainer spring into control rod hole now on back side of the bracket.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

FIG. 14

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents GTH225 Safety Rules Safe Operation Practices for Ride-On MowersBecome ALERT!!! Your Safety is IN- Volved Table of Contents Contents of Hardware Pack HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonAssemble Gauge Wheels to Mower Deck See Fig To Attach Front Bumper See FigTo Attach Nose Roller See Fig Install Mower and Drive Belt See Figs To SET UP Your Mower for Mulching See FigTo Install Mulcher Plate See Fig To Convert to Bagging or DischargingCheck for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Check Brake System3CHECKLIST Operation Know Your Tractor HOW to USE Your Tractor To Transport See Figs To Operate Mower See FigTo Operate on Hills Towing Carts and Other AttachmentsADD Gasoline Before Starting the EngineCheck Engine OIL Level See Fig To Start Engine See FigMowing Tips Purge TransmissionMulching Mowing Tips General Recommendations Lubrication ChartCustomer Responsibilities Before Each USETractor Engine Muffler CleaningEngine OIL Filter Spark PlugsTo Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See FigTo Replace Mower Drive Belt To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt To Adjust Attachment Clutch See FigTo Adjust Brake See Fig See FigFront Wheel TOE-IN Adjustment Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel CamberTo Replace Fuse To Replace Headlight BulbInterlocks and Relays To Adjust Choke Control See Figs To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig To Adjust Carburetor See FigFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionOFF Schematic Engine Connector Tractor ConnectorElectrical KEY Part Description Chassis and Enclosures Repair Parts Ground Drive KEY Part NO. NO. Description Steering Assembly Adapter, Wheel Steering Engine Spark Arrester KITSeat Assembly Decals Wheels & TiresLift Assembly 532171211 Retainer, SpringMower Deck Repair Parts Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideWarranty Statement Limited WarrantyRev 10.27.99 JH/TR/JH

GTH225 specifications

The Husqvarna GTH225 is a standout riding mower designed for those who seek a blend of performance, comfort, and reliability in lawn care. Engineered for durability and versatility, this model is perfect for homeowners who manage medium to large yards.

At the heart of the GTH225 is a robust and efficient engine. Powered by a 22 HP Kohler engine, it delivers consistent performance for cutting even the toughest grass. The engine is designed to ensure smooth operation and offers the torque needed for impressive cutting power. Additionally, the hydrostatic transmission allows for seamless speed adjustments, providing an easy and responsive driving experience.

One of the key features of the Husqvarna GTH225 is its cutting deck, which spans a wide 48 inches. This substantial deck size means fewer passes are required to cover large areas, making lawn maintenance quicker and more efficient. The cutting height can be adjusted from 1.5 to 4 inches, catering to different grass types and seasonal growth patterns. The deck is also equipped with high-quality blades, which provide clean cuts and a professional finish.

Comfort is a major consideration with the GTH225. The operator's seat is well-cushioned and ergonomically designed, enabling users to mow for extended periods without discomfort. The steering wheel and controls are intuitively placed, ensuring that operation is user-friendly and requires minimal effort.

The Husqvarna GTH225 is also built to enhance maneuverability. With a tight turning radius, it easily navigates around obstacles like trees and flower beds. This agility is complemented by its durable construction, featuring a sturdy frame that can withstand the rigors of regular use.

Another innovative feature is the optional mulching kit, which enhances the mower's versatility. It allows for superior grass recycling, thereby enriching the lawn without the need for bagging clippings. Additionally, the model can be equipped with a tow hitch for added functionality, enabling users to attach various gardening tools or trailers.

In line with Husqvarna’s commitment to environmental sustainability, the GTH225 is designed with fuel efficiency in mind, helping homeowners reduce their carbon footprint while keeping their lawns pristine. Overall, the Husqvarna GTH225 combines advanced technology, comfort, and performance, making it a reliable choice for anyone serious about maintaining their outdoor space.
Top Page Image Contents