Husqvarna YTH2448T owner manual Tractor, Brake Operation, Tires, Blade Care, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See PSI on tires).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

ROS "ON" Position

Engine "ON" Position

(Normal Operating)

 

02828

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

BLADE CARE

For best results mower blades must be sharp. Replace worn, bent or damaged blades.

CAUTION: Use only a replacement blade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 13)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new blade with stamped "GRASS SIDE" facing the ground.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

 

STAR

 

BLADE

CENTER

 

HOLE

 

 

 

BLADE BOLT

02544

MANDREL

(SPECIAL)

 

 

 

ASSEMBLY

FIG. 13

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Remove terminal guard.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 917.279200 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsTo Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips Before Each USE MaintenanceTires BatteryTractor Brake OperationEngine Tractor See Fig Service and AdjustmentsCleaning IN-LINE Fuel Filter See FigFirst Install ANTI-SWAY BAR S To Install Mower See FigsEH J To Level Mower Mower Drive Belt Installation To Replace Mower Blade Drive Belt See FigMower Drive Belt Removal To Remove Wheel for Repairs See Fig To Replace Motion Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Attach Jumper CablesTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when Service Notes Tractor Model no .279200 YTH2448T SchematicElectrical KEY Part NO. NO.DESCRIPTION Chassis KEY Part Description Drive KEY Part NO. NO.DESCRIPTION Steering Assembly Engine Spark Arrester KITSeat Assembly Wheels and Tires DecalsMower Deck KEY Part NO. NO.DESCRIPTION Mower Lift Service Notes Repair Parts Key Part Description Emission Label Label KIT Briggs Engine Model Number 445677, Type Number 0413-E1Carburetor Gasket SET Replacement Engine KEY Part Description KEY Part Description Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

YTH2448T specifications

The Husqvarna YTH2448T is a robust and reliable riding lawn mower designed for homeowners who wish to maintain their lawns efficiently and effortlessly. Combining modern technology with user-friendly design, this mower delivers impressive performance while ensuring comfort during extended use.

One of the standout features of the YTH2448T is its powerful 24 HP Briggs & Stratton Intek engine. This engine provides ample power for tackling various lawn conditions, ensuring that the mower can handle tall grass and rugged terrain without sacrificing performance. The engine also features an automatic choke system, making it easy to start even in cold temperatures.

Equipped with a 48-inch cutting deck, the YTH2448T offers a wide cutting path, allowing users to cover more ground in less time. The deck is made from high-quality materials to ensure durability and is designed with a reinforced cutting edge to prevent wear and tear. Additionally, the deck features an adjustable cutting height, allowing users to choose the optimal height for their lawn.

The mower also incorporates an innovative hydrostatic transmission system that provides seamless acceleration and speed control. This technology eliminates the need for shifting gears, making it easier for users to navigate their lawns with precision. The YTH2448T also boasts a tight turning radius, allowing for maneuverability around obstacles such as trees and flower beds.

Comfort is prioritized in the design of the YTH2448T. The mower features an ergonomic seating position with an adjustable seat to accommodate various user heights. The controls are intuitively placed within easy reach, allowing operators to focus on mowing without distraction. The mower is also equipped with a built-in cup holder, providing convenience for long mowing sessions.

Another impressive characteristic of the Husqvarna YTH2448T is its low vibration design, which enhances comfort and reduces fatigue during use. The mower's construction also includes sound damping technology, resulting in a quieter operation, making it suitable for residential neighborhoods.

In conclusion, the Husqvarna YTH2448T is an exceptional riding lawn mower that combines power, comfort, and efficiency. With its reliable engine, wide cutting deck, advanced transmission, and user-friendly features, it stands out as an ideal choice for homeowners looking to keep their lawns in pristine condition. Whether you are a seasoned lawn care enthusiast or a novice, the YTH2448T promises to make lawn maintenance a breeze.
Top Page Image Contents