7.When done, press the TOOLS button and then select the Copy to USB using the ▲▼ buttons. and then press the E button. The Copy to USB
8.Use the ▲▼ buttons to select the device to store the copied files, and then press the E button.
✎NOTES
Do not disconnect the device while copying is in progress.
9.If you want to cancel copying, press the E button and then select Yes. Select No to continue copying.
10.When copying is complete, the "Copying completed." message appears. Press the E button to go back to the Playback screen.
✎NOTES
This function may not be supported by some discs.
On the Copying screen, you can also choose Select All and Deselect All.
-Use Select All to select all item. This cancels your individual item selections.
-Use Deselect all to deselect all selected item at once.
Playing Photo Contents
You can control the playback of photo content located on a
Using the Tools Menu
During playback, press the TOOLS button.
Start Slide Show/ | Select to start or stop the slide |
Stop Slide Show | show. |
Slide Show Speed | Select to set a slide show's speed. |
Background | Select to listen to music while |
Music | viewing a slide show. |
Zoom | Select to enlarge the current |
picture. (Enlarge up to 4 times) | |
Rotate | Select to rotate the picture. (This |
will rotate the picture either | |
| clockwise or counter clockwise.) |
Information Shows the picture information.
✎NOTES
Depending on the disc or storage device, the Tools menu may differ.
To enable the background music function, the photo file must be in the same storage media as the music file.
However, the sound quality can be affected by the bit rate of the MP3 file, the size of the photo, and the encoding method.
You can't enlarge the subtitle and PG graphic in the full screen mode.
Appendix
| Troubleshooting | |
Before requesting service, please try the following solutions. | ||
|
|
|
PROBLEM | SOLUTION | |
No operation can be | Check the batteries in the remote control. They may need replacing. | |
performed with the remote | Operate the remote control at a distance of no more than 6.1m from the | |
control. | player. | |
| Remove batteries and hold down one or more buttons for several minutes | |
| to drain the microprocessor inside the remote control to reset it. Reinstall | |
| batteries and try to operate the remote control again. | |
Disc does not play. Ensure that the disc is installed with the label side facing up.
Check the region number of the
Disc Menu does not appear. Ensure that the disc has disc menus.
The prohibition message | This message appears when an invalid button is pressed. |
appears on the screen. | The |
| You’ve requested a title or chapter number or search time that is out of range. |
Play mode differs from the | Some of the functions selected in the Setup Menu may not work properly if |
Setup Menu selection. | the disc is not encoded with the corresponding function. |
The screen ratio cannot be | The Screen Ratio is fixed on your |
changed. | This is not a problem with the player. |
No audio. | Make sure you have selected the correct Digital Output in the Audio Options |
| Menu. |
The screen is blank. If the HDMI output is set to a resolution your TV cannot support (for example, 1080p), you may not see a picture on your TV.
Press the button (on front panel) for more than 5 seconds with no disc inside. All settings will revert to the factory settings.
When the factory default settings are restored, all stored user BD data is deleted.
20