Samsung DVD-CM500 DVD-CM500H/XEF Tuning Your Television for the DVD-VCR, Result, clearly, DVD-VCR, audio/video mode (AV), 1 Switch on the television, not

Tuning Your Television for the DVD-VCR

You must tune your television for the DVD-VCR only if you are not using a Scart cable

➢To view pictures from your DVD-VCR when a Scart

GB	cable is used, the television must be set to the
	audio/video mode (AV).

2

1 Switch on the television.

2 Switch on the DVD-VCR by pressing STANDBY/ON on the front of the DVD-VCR or STANDBY/ON on the remote control.

3 Select a programme position on the television to be reserved for use with your DVD-VCR.

4 Insert the video cassette in the DVD-VCR. Check that the DVD-VCR starts reading the cassette; if not, press ❿II button.

5 Start a scan on your television or set the television to UHF channel 36.

4	6	Fine tune the television until the pictures and sound are obtained
		clearly.

7If you cannot find the pictures and sound, or there is interference from nearby channels, it may be necessary to change the setting of the DVD-VCR output channel (see Setting the DVD-VCR Output Channel on page 23 and Problems and Solutions on page 75).

8When the picture and sound are perfectly clear, store this channel at the desired programme position on the television. Result: That programme is now reserved for use with your

DVD-VCR.

14