Samsung HDC9475TG/XEF, HDC9475TG/XEO ENGLISHGB, GENERAL, SAFETY PRECAUTION, INSTALLATION INSTRUCTIONS, 45 cm, Fig.5, MODEL, Fig.5, MODEL, Fig.5, Fig.1B, Fig.1A, 2 fase, Fig.4a, Fig.4b, 3A fuse

ENGLISHGB

GENERAL

Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations.

The appliance has been designed for use in the ducting version (air exhaust to the outside – Fig.1B), filtering version (air circulation on the inside – Fig.1A).

SAFETY PRECAUTION

Takecarewhenthecookerhoodisoperatingsimultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion.

The negative pressure in the environment must not exceed 4Pa (4x10-5 bar).

Provide adequate ventilation in the environment for a safe operation of the cooker hood. Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity network:

-Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician.

-If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre.

-This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse.

Warning !

In certain circumstances electrical appliances may be a danger hazard.

A)Do not check the status of the filters while the cooker hood is operating

B)Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation.

C)Flambè cooking is prohibited underneath the cooker hood

D)Avoid free flame, as it is damaging for the filters and a fire hazard

E)Constantly check food frying to avoid that the overheated oil may become a fire hazard

F)Disconnect the electrical plug prior to any maintenance.

G)This appliance is not intended for use by young children or infirm persons without supervision

H)Young children should be supervised to ensure they do not play with the appliance

I)There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels

L)There is a risk of fire if cleaning is not carried out in accordance with the instructions.

This appliance conforms to the European Directive EC/2002/96,

Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner, the user is helping to prevent potential damage to the environment or to public health.

The symbol on the product or on the accompanying

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to a suitable electric and electronic appliance recycling collectionpoint. Followlocalguidelineswhendisposingofwaste. For more information on the treatment, re-use and recycling of this product, please contact your local authority, domestic waste collection service or the shop where the appliance was

purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out by specialised personnel.

• Electric Connection

The appliance has been manufactured as a class II, therefore no earth cable is necessary.

The plug must be easily accessible after the installation of the appliance.

If the appliance is equipped with power cord without plug, a suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be fitted between the appliance and the electricity supply in compliance with the load and current regulations.

The connection to the mains is carried out as follows: BROWN = L line

BLUE = N neutral

•If the hob is electric, gas, or induction, the minimum distance between the same and the lower part of the hood must be at least 45 cm.

If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cookerhoodexhausttothesameconductorusedtocirculatehot air or for evacuating fumes from other appliances generated by other than an electrical source.

•In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.

•We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier.

•Before starting to fix the hood, disconnect the anti-grease filter B (Fig.5) for easier appliance handling.

Before this operation, perform the following steps depending on the model purchased:

MODEL 1

Remove the 3 panels A as shown in Fig.4a.

Pull handle B as shown in Fig.5.

MODEL 2

Open panel C as shown in Fig.4b.