Samsung HT-D5300 HT-D5300/ZA Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit, Connections, NOTE, ✎NOTE, CAUTION, !CAUTION, 22 English

Connections

!CAUTION

Do not insert any other card except the TX card dedicated to the product.

If you insert a different TX card, you can damage the product and may not be able to remove the card easily.

Do not insert the TX card upside down or in the reverse direction.

Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.

If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the Surround Speaker connectors on the product.

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro Logic II.

In 2-CH mode, you will hear no sound from the wireless surround speakers.

✎NOTE

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound from the speakers may be disrupted because of interference.

If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.

The maximum transmission distance from the product to the wireless receiver module is about 33 feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

If the product doesn’t make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the product turned off, press “0””1””3””5” on the remote control. Turn on the wireless receiver module. Then, press and hold the “ID SET” button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit

If you attach a Toroidal ferrite core to the power cord of the man unit, it will help to prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.2.Make a loop twice in the main unit power cord.

3.Attach the Toroidal ferrite core to the main unit power cord as the figure shows and press it until it clicks.

FM ANT	COMPONENT OUT		SPEAKERS OUT
			CENTER	FRONT	SURROUND
			SUBWOOFER	FRONT	SURROUND
WIRELESS	AUX IN	VIDEO OUT	SPEAKER IMPEDANCE : 3

22 English

HT-D5300_XAA_1226.indd 22 2011-12-26 ￿￿ 11:39:30