Samsung 820TSN 700TSN Connecting HDMI, Connecting to a Wired Remote Control, Connecting Using a DVI to HDMI Cable

LH82TCTMBC/EN, LH70TCTMBC/EN

Download on canonical page 33 pages, 0 b

•Connect a set of audio cables between the AUX L, R jacks on the AUDIO SYSTEM and the AUDIO OUT [L-AUDIO-R] on LCD Display.

Connecting to a Wired Remote Control

Note

•You can control your monitor by allowing it to receive the remote control signals of other devices through the REMOTE OUT terminal.

•You can control a device by allowing it to receive remote control signals from other devices through the REMOTE IN terminal.

Note

• Restrictions: Available only if other devices support the wired remote control I/O terminals.

Connecting HDMI

Note

•Input devices such as digital DVD are connected to the HDMI IN terminal of the monitor using the HDMI cable.

Note

• You cannot connect a PC to the HDMI IN terminal.

Connecting Using a DVI to HDMI Cable

Models

1SyncMaster 700TSn, 820TSn
Package Contents
Your LCD Display
Mechanical Layout
2Introduction
- 3Other
- Batteries (AAA X 2)
- Remote Control(Not available in all
- BNC to RCA
- locations)
- Sold separately
- Adaptor Jack
- Wall Mount KIT
- DVI Cable
- BNC Cable
- LAN Cable
- Your LCD Display
- Front
- 1)MENU
- 2)Navigate buttons (Up-Downbuttons)
- 3)Adjust buttons (Left-Rightbuttons)/ Volume buttons
- 4)ENTER
- 5)SOURCE
- 46)PIP
- •PC
- •BNC
- •DVI
- •AV / S-Video
- •Component
- •HDMI
- 7)Power button
- 8)Brightness Sensor
- 9)Power indicator
- 10)Remote Control Sensor
- 10)
- Rear
- 51)POWER IN
- 2)REMOTE OUT/IN
- 3)RS232C OUT/IN (RS232C Serial PORT)
- 5)DVI / PC / HDMI IN [HDMI]
- 6)DVI / PC / HDMI IN [RGB] (PC Video Connection Terminal)
- 7)DVI / PC / HDMI IN [DVI(HDCP)] (PC Video Connection Terminal)
- 8)COMPONENT AUDIO IN [L-AUDIO-R](Component Audio Connection Terminal (Input))
- BNC/COMPONENT OUT [R/P
- 611) AV AUDIO IN [L-AUDIO-R](LCD Display
- Audio Connection Terminal (Input))
- 12) AV OUT [VIDEO] (VIDEO Connection Terminal): AV mode (Output)
- 13) AV IN [VIDEO] (VIDEO Connection
- Terminal) (Input)
- 14) AV OUT [S-VIDEO] (S-VIDEOConnection Terminal): S-VIDEOmode (Output)
- 15) AV IN [S-VIDEO] (S-VIDEOConnection
- 16) AUDIO OUT [L-AUDIO-R](LCD Display
- Audio Connection Terminal (Output))
- 17) LAN (LAN Connection Terminal)
- 18) USB (USB Connection Terminal)
- Remote Control
- 71. ON / OFF
- 2. MagicInfo
- 3. MDC
- 4. LOCK
- 5. MagicInfo buttons
- 7. VOL
- 8. MUTE
- 9. TTX/MIX
- 10. MENU
- 11. ENTER
- 12. P.MODE
- 13. AUTO
- 14. ENTER/PRE-CH
- 15 . CH/P
- 16. SOURCE
- 17. INFO
- 18. EXIT
- 19. Up-Down Left-Rightbuttons
- 20. S.MODE
- 21. STILL
- 22. FM RADIO
- 23. P.SIZE
- 24. SRS
- 25. DUAL/MTS
- 26. PIP
- 27. SOURCE
- 28. SWAP
- 29. SIZE
- 30. REW
- 31. STOP
- 32. PLAY/PAUSE
- 33. FF
- 1)ON / OFF
- 2)MagicInfo
- 3)MDC
- 4)LOCK
- 5)MagicInfo buttons
- -This fuction does not work for this monitor
- 7)VOL
- 8)MUTE
- 8This is displayed on the lower left corner of the screen
- The audio resumes if MUTE or - VOL + is pressed in the Mute mode
- 9)TTX/MIX
- TV channels provide text information services via teletext
- 10)MENU
- 11)ENTER
- 11)
- 12)P.MODE
- AV / S-Video /Component : P.MODE
- ( Dynamic → Standard → Movie → Custom )
- PC/DVI/BNC : M/B (MagicBright™)
- 13)AUTO
- 13)
- Adjusts the screen display automatically in PC mode
- By changing the resolution in the control panel, auto function is performed
- 14) ENTER/PRE-CH
- 14)
- Returns to the immediately previous channel
- 15)CH/P
- 15)
- In TV mode, selects TV channels
- 16)SOURCE
- 16)
- Changes the video source
- 17)INFO
- 17)
- 18)EXIT
- 18)
- Exits from the menu screen
- 19)Up-Down Left-Rightbuttons
- 19)
- 20)S.MODE
- 20)
- 21)STILL
- 21)
- Press the button once to freeze the screen. Press it again to unfreeze
- 22)FM RADIO
- 22)
- Turns the FM Radio on/off
- In PC/DVI mode, sets the SOUND to FM Radio
- In general Video mode, selects FM Radio, and turns off the screen
- In areas where the signal is weak, noise may occur during FM radio broadcasts
- 23)P.SIZE
- 23)
- Press to change the screen size
- 24)SRS
- 24)
- SRS
- 925) DUAL/MTS
- DUAL
- MTS
- You can select MTS (Multichannel Television Stereo) mode
- Audio Type MTS/S_Mode
- Default
- Mono
- Manual Change
- FM Stereo Stereo
- Stereo
- SAP
- - This fuction does not work for this monitor
- 26)PIP
- 26)
- Every time you press the button, a PIP screen appears
- 27)SOURCE
- 27)
- Changes the source of the PIP window signal
- 28)SWAP
- 28)
- Swaps the contents of the PIP and main image
- 29)SIZE
- 29)
- Switches the PIP Picture Size
- 30)REW
- 30)
- Rewind
- 31)STOP
- 31)
- Stop
- 32)PLAY / PAUSE
- 32)
- Play/Pause
- 33)FF
- 33)
- Fast forward
- © 1995~2008 SAMSUNG. ALL Rights Reserved
101. Mechanical Layout
2. Monitor Head
113.Installation VESA Bracket
Dimensions
124.Wall Bracket Installation
Components
- Anchor
13To mount the product on the wall bracket
14Wall Bracket Angle Adjustment
22Connections
- 23Using a Power cord with Earth
- Connecting a Computer
- DVI(HDCP) port
- DVI port
- BNC/COMPONENT IN - R, G, B, H, V ports
- 15 pin
- D-sub
- Port
- 24Connecting a VCR
- AV IN [VIDEO]
- AV IN
- [S-VIDEO]
- S-Video
- Connecting a DVD Player
- 25COMPONENT AUDIO IN
- [L-AUDIO-R]
- BNC/COMPONENT IN - P
- , Y, P
- port
- Component
- Connecting a Camcorder
- 26Connecting a DTV Set Top Box
- BNC / COMPONENT IN - P
- Connecting to an Audio System
- 27Connecting to a Wired Remote Control
- Connecting HDMI
- Connecting Using a DVI to HDMI Cable
- 28Connecting a LAN Cable
- Connecting a USB device
- Self-TestFeature Check
- Check List
29Troubleshooting
- 30Maintenance and Cleaning
- 1)Maintaining the LCD Display Case
- Clean with a soft cloth after disconnecting the power cord
- •Do not use benzene, thinner or other flammable substances, or a wet cloth
- •Never use acetone, benzene or thinner
- (They may cause flaws or deformation of the screen surface.)
- Symptoms and Recommended Actions
- Service Center or your dealer
- 2)Check if the computer beeps more than 3 times when booting
- (If it does, request an a service for the main board of the computer.)
- Check List
- please call the phone number on the Information section or contact your dealer
- For more
- MagicInfo Troubleshooting
- Problems related to the Installation (PC Mode)
- Problems
- Solutions
- The LCD Display screen flickers
- 31Problems related to the Screen
- The screen is blank and the power indicator is off
- "Check Signal Cable" message
- "Not Optimum Mode " message
- The picture rolls vertically
- The image is not clear; picture is blurred
- The picture image is unstable and shakes
- Ghost images are shown in the picture
- The image is too light or too dark
- The screen color is inconsistent
- The color image is distorted by dark shadows
- The color white is poor
- The power Indicator blinks green
- The screen is blank and it is blinking
- Problems related to Audio
- 32No sound
- The sound level is too low
- The sound is too high or too low
- Problems related to the Remote Control
- The remote control buttons do not respond
- Problems related to MagicInfo
- ProblemsSolutions
- Making a Bootable USB Flash Disk
- Question
- How can I change the frequency
- How can I Adjusts the resolution
- Answer
- 33How can I set the Power Saving function
- How can I clean the outer case/LCD Panel
- How can I play the video

Models

Contents