Samsung F2080 5 Troubleshooting, 5-1Monitor Self-Diagnosis, 5-2Before Requesting Service

5 Troubleshooting

5-1 Monitor Self-Diagnosis

• You can check if the product is working properly using the Self-Diagnosis function.

•If a blank screen is displayed and the Power LED blinks even if the product and the PC are properly connected, perform the self-diagnosis function according to the procedures below.

1.Turn the product and the PC off.

2.Separate the signal cable from the product .

3.Turn the product on.

4.If the product is working properly, the 'Check Signal Cable' message appears.

In this case, if a blank screen is displayed again, make sure that there is no problem with the PC and the connection. The product is working properly.

5-2 Before Requesting Service

Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest Samsung Electronics Service Center.

A blank screen appears / I cannot turn the product on

Is the power cord connected properly?	Check the connection status of the power cord.
Is the “Check Sinal Calbe” message displayed on the screen?	Check the cable connecting the PC and the product.
	If the message appears on the screen even if the cable is
	properly connected, recheck the input signal by pressing the
	/SOURCE button of the product.
Is the “Not Optimum Mode” message displayed on the	This occurs when the signal from the graphics card exceeds
screen?	the maximum resolution or the maximum frequency of the
	product.
	In this case, set up the appropriate resolution and the fre-
	quency for the product.
Is a blank screen displayed and does the power LED blink at	This occurs when the power saving function is running.
a 1 second interval?	If you click the mouse or press any key, the screen will be
	turned on.
Did you connect with a DVI cable?	If you connect the DVI cable when the PC has booted up or if
	you reconnect the DVI cable after disconnecting the cable
	while using a PC, the screen may not be displayed because
	some graphics cards do not output the video signal.
	In this case, reboot the PC while the DVI cable is connected.
The on screen adjustment menu (OSD) does not appear.
Did you cancel the screen adjustment?	Check if the <OSD Adjustment Lock> function is set to Off.
The color is weird / The picture is displayed in black and white
Is the entire screen displayed in the same color as if viewing	Check the cable connection to the computer.
the screen through a cellophane paper?	Reinsert the graphics card into the computer completely.
	Check if the <Color Effect> is set to <Off>.
Is the graphics card configured correctly?	Set up the graphics card referring to the user manual.

Troubleshooting 5-1