Samsung MM-S8 MMS8RH, MMS8RH/ELS Connecting your System to the Power Supply, Where to Install Your, Micro Component System, Inserting Remote Control Batteries

Where to Install Your

Micro Component System

To take full advantage of your new micro component system, follow these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

		Volume
DEMO/
DIMMER	TUNER	CD
	Band
	TAPE	AUX
REV.MODE
		SRS WOW
CD SYNC.	TUNING	STOP
	MODE
		OPEN/CLOSE
	/DOWN	UP/

PHONES

Connecting your System to the Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage.

1	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
2	Press the (	) button to switch your micro component system on.

Inserting Remote Control Batteries

GB

Insert or replace remote control batteries when you:

Purchase the micro component system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery
	compartment cover (rear of the remote control) and push the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:
	+ on the battery against + in the battery compartment
	– on the battery against – in the battery compartment
3	Replace the cover by sliding it back until it clicks into position.

7