Where to Install Your
Micro Component System
To take full advantage of your new micro component system, follow these installation instructions before connecting the unit.
| TUNER | Open/Close |
Standby/On |
|
|
| VCD/CD |
|
| TAPE |
|
Phones | AUX | Mic |
Full Auto Remote Control Operation
Connecting your System to the Power Supply
The main lead must be plugged into an appropriate socket.1 | Check the position of the voltage selector on the rear panel |
2 | (OPTIONAL). |
Plug the main lead (marked AC Cord on the rear of the system) into | |
3 | an appropriate socket. |
Press the Standby/On button to switch your |
Inserting Remote Control Batteries
GB
Insert or replace remote control batteries when you:1 | Place your thumb on the position marked on the battery |
| compartment cover (rear of the remote control) and push the cover in |
| the direction of the arrow. |
2 | Insert two AA, R6 or equivalent batteries, taking care to respect the |
| polarities: |
| + on the battery against + in the battery compartment |
| – on the battery against – in the battery compartment |
3 | Replace the cover by sliding it back until it clicks into position. |
7