How to use OSD Menu
•ATW1(Auto Tracing White Balance mode 1): The camera can automatically adjust the color temperature in real time, according to the ambient conditions. The color temperature ranges from approx. 2500K to 9300K.
•ATW2: The color temperature ranges from approx. 2,000K to 10,000K.
•AWC ( Auto White Balance Control): If you press the SETUP switch in the appropriate item position, Auto White Balance will perform once.
•3200K : Set color temperature to 3200K
•5600K : Set color temperature to 5600K
–RED : Adjusts the strength of the red color.
–BLUE : Adjusts the strength of the blue color.
–R-GAIN/B-GAIN : Enables you to set the current color temperature manually.
–BRIGHTNESS : Select a brightness level in switching from setting in DAY mode to setting in NIGHT mode.
❖ DIGITAL ZOOM | [ON/OFF] |
You can set the digital zoom factor and position. If you press the SETUP switch with the DIGITAL ZOOM function set to ON, you will see the appropriate screen.
When the zoom factor and position are defined, the digital zoom function will operate.
DIGITAL ZOOM
RATIO |
| [X1.0] |
|
< LOCATION > |
|
| |
| |||
-LOCATION : If you press the SETUP switch in the condition where the image is enlarged as much as the
ratio setting, you can watch an invisible area of the effective screen as well using the switch.
Note :
–If the digital zoom factor is set to larger than 1x, the FENCE function will be deactivated.
The DIGITAL ZOOM function enlarges the pixel itself, which can cause deterioration of the quality.
❖DETAIL [0~3]
Controls the horizontal or vertical distinction.
❖ | [INT, LINE] |
Select the vertical sync mode for INT or LINE.
If you select INT, the camera will use the internal synchronization.
If selecting LINE, the camera will use the external power source frequency for the synchronization.
You can adjust the LL-PHASE.
ENG
English – 23