Installation
ADJUSTING THE CAMERA DIRECTION
When the camera is fixed on the ceiling, you can adjust the camera viewing angle. You can rotate your camera leftward or rightward (Panning), and can change the slope of your camera upward or downward (Tilting).
In case of panning, the rotation limit of your camera is set to 355 degree (100 degree clockwise and 255 degree counterclockwise). The rotation is stopped by the Stopper inside of the camera. For panning control, first unfasten two screws located on the bottom and rotate in the direction you want, and then fasten them to fix the camera.
In case of tilting, you can change the slope of your camera | |||||
from zero to 90 degree. However if the slope angle is |
|
|
|
|
|
under 17 degree, you can encounter a partial image hide |
|
|
|
|
|
|
|
|
|
| |
problem. To fix the location after adjusting the tilting angle, |
|
|
|
|
|
use the Tilt fixing screws. |
|
|
|
|
|
To adjust the focus and zoom of your camera, use the Zoom lever and Focus lever. When you install the camera on the inclined ceiling or wall, you can rotate the camera lens to see a correct direction image.
ENG
English – 13