Heating Your Room
You must select the Heat mode if you wish to adjust the:
◆Heating temperature
◆Fan speed when heating
1If necessary, press the
Result: ◆ The operation indicator on the indoor unit lights up.
◆The air conditioner starts up in the mode selected when the unit was last used.
◆The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
It will start up normally after three minutes.
2If the
Result: | ◆ The indoor unit beeps each time you press the | button. |
| ◆ The air conditioner runs in HEAT mode. |
|
Note | You can change modes at any time. |
|
3To adjust the temperature, press the
Possible temperatures are between 16°C and 30°C inclusive.
Result: ◆ Each time you press the
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆The air conditioner starts heating, provided that the room temperature is lower than the desired temperature (selected temperature+3°C).
◆If the room temperature reaches the set temperature, the air conditioner stops heating, but the fan is still operating.
4Select the fan speed by pressing the
Automatic (rotated :
Low
Medium
High
Result: ◆ Each time you press the
slowly until the air has been sufficiently warmed. Once the correct temperature has been reached, the fan is automatically set to the required speed.
5To control the direction of the air flow, refer to pages 16 and 17.