ENG-15
C
ONNECTIONS
Before Connecting the DVD-VCR-Always turn off the DVD-VCR, TV, and other components before you connect or disconnect any cables.
- Refer to the user’s manual of the additional components (such as a TV) you are connecting for more
information on those particular components.
Connection to a TVThe following shows examples of connections commonly used to connect the DVD-VCR with a TV and other
components.
Connection to a TV (Video)
1
Using video/audio cables, connect the VIDEO
(yellow)/AUDIO (red and white) OUT terminals
on the rear of the DVD-VCR to the VIDEO
(yellow)/AUDIO (red and white) IN terminals of
your TV.
2
Turn on the DVD-VCR and TV.
3
Press the input selector on your TV remote
control until the Video signal from the DVD-VCR
appears on the TV screen.
Notes
- Noise may be generated if the audio cable is placed too close to the power cable.
-If you want to connect to an Amplifier, please refer to the Amplifier connection page.
(See pages 19 to 20).
- The number and position of terminals may vary depending on your TV set. Please refer to the user's manual
of your TV.
- If there is one audio input terminal on the TV, connect it to the LINEOUT AUDIO OUT Left (white) terminal of
the DVD-VCR.
- If you press the P.SCANbutton when DVD-VCR is in stop mode or no disc is inserted, the Alt Video Out
mode changes in the following sequence: (S-Video - Interlace - Progressive)
White
White YellowRed
Audio Cable
Video Cable
Red
Yellow
01304A_V6700_XAC_Eng1 1/18/07 11:58 AM Page 15