1.Insert the rat protection panel to the assembling hole on back side to the end.
2.If you have difficulty inserting the panel lift up the washer a little and insert it
Take out the
Be sure to join tightly the drain hose into the
Be sure to join tightly the drain hose into the
Install the drain hose in the position of about 90~100cm above the ground.
90~100cm
•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener Inlet.•Using too much softener may produce unsatisfactory results.•Do not leave the softener into the Softener
Dispenser for a long time. Because softner became stiff.1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2. Put in
Put the detergent in proportion to water level
Softener Device Softener baseline
CAUTION : If softener is stored over the above base line, it may flow down at any time.
8