Samsung WA10R3 manual 11

■ASSEMBLING THE RAT PROTECTION PANEL

Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw to the base as shown in the figure.

Rear-side

1.Insert the sound absorbing panel to the assembling hole on back side to the end

2. If you have difficulty inserting the panel lift up the washer a little and insert it.

■HOW TO CONNECT THE DRAIN HOSE

☞IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and	Be sure to join tightly the drain hose into
connect the outlet-hose.	the drain-outlet on the back of the
	machine.

Be sure to join tightly the drain	Install the drain hose in the position of
hose into the drain-outlet on	about 90~100cm above the ground.
the side of the machine.
	90~100cm

☞IN CASE OF GENERAL WASHER

1.After pressing the joint ring, insert to the drain hose.

2. After directing the drain hose to a drain, join to the drain-outlet of the washing machine.

drain-outlet

3. Be sure to join them tightly by pressing the joint ring and pushing it into the drain-outlet.

• The length of drain hose is adjustable so that you can extend the length appropriately.

HOW TO CHANGE THE DRAIN HOSE DIRECTION

• The handle of joint ring is pressed to pull out the drain hose. Change the direction of the drain hose and follow the above guideline again.

CAUTIONS WHEN INSERTING THE DRAIN HOSE

1. Don’t exceed more than 3m when the	Less than 3m
drain hose is used by connecting whth
other hoses.

2.Be careful to drain water out at the end of the drain hose.

3. The doorsill shoudn’t be more than	Less than 3m
5cm.

Less than 5cm

4.Don’t install the drain hose underneath the wash machine.

- 11 -