Samsung WA13RA ■CONNECTINGTHEWATER SUPPLY HOSE, ■ASSEMBLINGTHE RAT PROTECTION PANEL, ■HOWTO CONNECTTHE DRAIN HOSE

■CONNECTINGTHEWATER SUPPLY HOSE

1. Remove the adaptor from the water supply hose.

2. First, using a“+” type screw driver, loosen the four screws on the adaptor. Next, take the adaptor and turn part(b) following the arrow for gap about 5 mm between them.

3.Connect adaptor to the water tap by tightening the

screws firmly. Then, turn part(b) following the arrow and
put (a) and (b) together.	a
	b
4. Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c)
is released, the hose is automatically connected to the	c
adaptor making a‘click’ sound.
5. Connect the other end of the water supply hose to the
inlet water valve at the back of the washer. Screw the
hose clockwise all the way in.

5-1.Connect the other end of the water supply hose to the inlet water valve at the top of the washer. Screw the hose clockwise all the way in.

☞ If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown..

After completing connection, if water leaks from the hose, then repeat

Note! the same steps.

Use the most conventional type of faucet for water supply.

In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

■ASSEMBLINGTHE RAT PROTECTION PANEL

Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw to the base as shown in the figure.

Rear-side

1.Insert the sound absorbing panel to the assembling hole on back side to the end

2.If you have difficulty inserting the panel lift up the

washer a little and insert it.

* THE PROTECTION PANEL IS NOT APPLIED IN SOME MODELS.

■HOWTO CONNECTTHE DRAIN HOSE

☞ IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and	Be sure to join tightly the drain hose into the
connect the outlet-hose.	drain-outlet on the back of the machine.
cap-hose

Be sure to join tightly the drain	Install the drain hose in the position of about
hose into the drain-outlet on	90~100cm above the ground.
the side of the machine.
	90~100cm

- 11 -