☞IN CASE OF GENERAL WASHER
1.After pressing the joint ring, insert to the drain hose.
2. After directing the drain hose to a drain, join to the
3. Be sure to join them tightly by pressing the joint ring and pushing it into the
• The length of drain hose is adjustable so that you can extend the length appropriately.
HOWTO CHANGETHE DRAIN HOSE DIRECTION
• The handle of joint ring is pressed to pull out the drain hose. Change the direction of the drain hose and follow the above guideline again.
CAUTIONSWHEN INSERTINGTHE DRAIN HOSE
1.Don’t exceed more than 3m when the drain hose
is used by connecting whth other hoses. |
|
| Less than 3 m |
|
| |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2. Be careful to drain water out at the end of the |
drain hose. |
■HOWTO ADDTHE FABRIC SOFTENER 
•When a proper amount (one time does) of fabric softener is stored in the softener inlet, it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener
Inlet.
•Using too much softener may produce unsatisfactory results.
•Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener.
Dispenser for a long time. Because softner became stiff.
■HOWTO PUTTHE DETERGENT IN 
1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.
2.Put in
over the box.
Detergent Device Put the detergent in proportion to Water level
Softener Device Softener baseline 
CAUTION : If softener is stored over the above base line, it may flow down at any time.
■WATER SUPPLY CONNECTOR FILTER
3. The doorsill shoudn’t be more than 5cm. |
Less than 3 m
Less than 5 cm
4.Don’t install the drain hose underneath the wash machine.
1.Pull out the filter and wash well.
inlet water valve
2.Pull in the filter and connect the hose to the inlet water valve tightly.
3.Check if there is a leakage.
Note to tighten up the connector.
- 12 -