INSTALLATION & MAINTENANCE
The User’s Manual is for common use.
Make use of the User’s Manual depending upon your washing machine model.
■ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic an electrical components are affected by direct heat, never place the washer near furnaces, boilers, etc. Do not place under direct sunlight.
■LEVELLING
•If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.
SEE IFTHE MACHINE IS PLACED LEVEL BY CHECKINGTHE POSITION OFTHE
WASHINGTUB.Water
•Open the lid of the machine, pour water into
the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.
•Place the machine more than 10cm away from the wall.
•Adjust the legs on feet.
LevelingWith the Leveling Screw (Manual Adjustable Feet)
|
|
|
|
• Gently lift up the machine | • | When done, put | • After adjusting |
and turn the adjustable |
| it down to the | the feet, do not |
feet to the left to find the |
| original position. | forget to fasten |
optimal balance. |
|
| the locking nut for |
|
|
| safety purposes. |
|
|
| (Failing to do so |
|
|
| may cause it to |
|
|
| loosen) |
|
|
|
|
ADJUSTMENTTHE HEIGHT OFTHE MACHINE
Adjust the legs to level the washer.
Be careful not to put in your hand under the legs. Pull the handles located at the right and left of the front side and slide off.
Adjust the height of the machine upward or downward.
When the adjustment is finished, push the handles to fix the adjusting legs.
Waterdrop Cause | How to level |
mark |
|
The front part is | Level it by adjustable legs. |
lower |
|
The back part is | Adjust the height by using the adjustable |
lower | rubber or prop at the back. |
The left part is lower | Adjust the left part by using the |
| adjustable legs at the front and the |
| adjustable rubber at the back. |
The right part is | Adjust the right part of the washer by |
lower | using the adjustable leg at the front and |
| the adjustable rubber at the back. |
- 10 -