About the refill indicator | Cleaning |
ꞏꞏ If the indicator on the auto dispenser section lights up, immediately refill the corresponding compartment. A later refill may cause the input level of the agent to decrease.
ꞏꞏ The input or refill level of the detergent or softener depends on the type or the remaining amount of agents.
ꞏꞏ Once you refill the auto dispenser, the remaining level of the detergent starts to be sensed upon the press of the Start/
Pause (Hold to Start) button. However, the
To refill the detergent or fabric softener
1. Slide open the detergent drawer.2. Apply an appropriate amount of detergent to the AutoDetergent compartment ( CAUTION
Make sure both the auto and manual dispensers are empty before moving the washing machine.
ꞏꞏ If the refill indicator continues to turn on after refilling the detergent/softener, press Start/Pause (Hold to Start). The indicator turns off about 10 seconds later.
ꞏꞏ The Refill indicator turns on because it is designed to remind you of the necessity for replenishment of detergent. This is not a system failure.
Troubleshooting
Symptom | Action |
The auto dispenser | ꞏꞏ Check if the detergent drawer is closed properly. |
indicators blink. | −− Open the detergent drawer and close it again. Make sure it’s closed |
(applicable models only) | properly. |
| ꞏꞏ This may happen if liquid detergent has hardened inside the detergent |
| compartment. |
| −− Clean and unclog the detergent compartment. |
|
|
1.While holding down the release lever on the inner of the drawer, slide open the drawer.
2.Remove both the detergent compartment and the softener compartment as shown.3.Open the lids of both compartments, and then put water in them and shake.4.Clean the cap valves of both compartments with a soft brush.5.Clean the drawer components in flowing water using a soft brush.6.Clean the drawer recess using a soft brush. Make sure to clean the cap valves to prevent clogging.
7.Assemble the compartment cover firmly with the detergent drawer.8.Slide the drawer inward to close it.※For details, refer to the user manual.
|
| ||
|
| ||
|
|
|
|