Desa Tech CCL3018NR, CCL3018PR, CCL3018NRA, CCL3018PRA, CCL3924NR, CCL3924PR, CCL3924NRA, CCL3924PRA, CHL3924NR, CHL3924PR, CCL3930NR, CCL3930PR, CCL3930NRA, CCL3930PRA manuals

36 pages1.01 Mb

2Air for Combustion and Ventilation
- 4SAFETY INFORMATION
- LOCAL CODES
- 5PRODUCT IDENTIFICATION
  - Figure 1 - Vent-Free Gas Log Heater (Logs May Vary By Model)
- UNPACKING
- PRODUCT FEATURES
  - OPERATION
  - SAFETY PILOT
  - PIEZO IGNITION SYSTEM
- REMOTE CONTROL ACCESSORIES
  - 6PROVIDING ADEQUATE VENTILATION
    - Ventilation Air From Outdoors
    - Determining Fresh-Air Flow For Heater Location
  - DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION
  - 7National Fuel Gas Code, ANSI Z223.1/NFPA 54 Section 5.3
  - .
    - or applicable local codes
      - VENTILATION AIR
        Figure 3 - Ventilation Air from Outdoors
        Figure 2 - Ventilation Air from Inside Building
  - 9Install- ing Damper Clamp Accessory for Vented Operation,
    - Figure 5 - Heat Resistant Material (Slate, Marble, Tile, etc.) Above Fireplace
    - 10MANTEL CLEARANCES
    - Figure 6 - Minimum Mantel Clearances Without Using Hood
    - Figure 7 - Minimum Mantel Clearances When Using Hood
    - 11FLOOR CLEARANCES
      - Figure 9 - Minimum Fireplace Clearances Above Combustible Flooring
      - Figure 8 - Minimum Fireplace Clearances If Installed at Floor Level
    - INSTALLING DAMPER CLAMP ACCESSORY FOR VENTED OPERATION
  - 14Con- necting to Gas Supply
    - Figure 15 - Equipment Shutoff Valve
    - Figure 16 - Checking Gas Joints
    - Figure 17 - Checking Gas Joints
    - 15INSTALLING REMOTE RECEIVER UNIT
    - 16INSTALLING WIRELESS HAND- HELD REMOTE CONTROL ACCESSORY
      - Figure 19 - Installing Remote Receiver
      - Figure 20 - Connecting Wires
      - Figure 21 - Installing Receiver on the Back of the Base
      - Figure 22 - Installing Battery in Hand- Held Remote Control Unit (CGHRCB Series)
      - Figure 23 - Installing Battery in Hand- Held Remote Control Unit (CGHRCTB Series)
      - 18Figure 27 - Installing Crossover Log (#4)
      - Figure 28 - Installing Crossover Log (#5)
      - Figure 31 - Installing Crossover Log (#7) to Models CCL3930PR/PRA and CCL3930NR/NRA Only
      - Figure 30 - Installing Crossover Log (#6)
      - Figure 29 - Installing Crossover Log (#5)
        (CCL3018PR/PRA and CCL3018NR/NRA Only)
    - Figure 33 - Pilot
    - Figure 32 - Control Knob and Ignitor Button Location
    - 20TO TURN OFF GAS TO APPLIANCE
    - MANUAL LIGHTING PROCEDURE
    - OPTIONAL HAND-HELD REMOTE OPERATION
      - IMPORTANT:
      - Note:
    - NOTICE: You must light the pilot before using the hand-held re- mote control unit. See
  - 21Lighting Instructions
    - on page 19.
      - ON/OFF SERIES (MODEL CGHRCB)
        Figure 35 - On/Off Hand-Held Remote Control Unit (CGHRCB)
      - THERMOSTAT SERIES (MODEL CGHRCTB)
        Figure 36 - Thermostat Hand-Held Remote Control Unit (GHRCTB)
- 22INSPECTING BURNERS
  - PILOT FLAME PATTERN
    - Figure 38 - Incorrect Pilot Flame Pattern
    - Figure 37 - Correct Pilot Flame Pattern
- 23CLEANING AND MAINTENANCE
  - BURNER INJECTOR HOLDER AND PILOT AIR INLET HOLE
    - Figure 39 - Injector Holder On Outlet Burner Tube
    - Figure 40 - Pilot Inlet Air Hole
  - LOGS
  - MAIN BURNER
  - 27IMPORTANT
  - www.desatech.com 111161-01D
  - 28
- 28ILLUSTRATED PARTS BREAKDOWN
  - MODELS CCL3018PR, CCL3018PRA, CCL3018NR, AND CCL3018NRA
    - Items 16 and 17 are Natural Gas only.
- 29PARTS LIST
  - www.desatech.com 111161-01D
  - 30
- 30ILLUSTRATED PARTS BREAKDOWN
  - Items 28 and 29 are Natural Gas only.
- 31PARTS LIST
- 32SPECIFICATIONS
- WIRING DIAGRAM
- TECHNICAL SERVICE
- SERVICE HINTS
- 33REPLACEMENT PARTS
  - PARTS UNDER WARRANTY
  - PARTS NOT UNDER WARRANTY
- PARTS CENTRAL
- 34ACCESSORIES
- 36WARRANTY INFORMATION
  - KEEP THIS WARRANTY
  - LIMITED WARRANTY COMFORT GLOW VENT-FREE GAS LOG HEATERS