INSTALLATION
Continued
WARNING: This appliance is equipped for (natural or pro- pane/LP) gas. Field conversion is not permitted.
INSTALLATION AND CLEARANCES
WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling, and adjoining wall.
MINIMUM FIREPLACE CLEARANCE
TO COMBUSTIBLE MATERIALS
| Side Wall 16" |
| Ceiling: 42" | |||
|
|
|
|
|
|
|
| LOG SIZING REQUIREMENTS | |||||
|
|
| Minimum Firebox |
| ||
Log |
|
|
|
| Front | Rear * |
Size |
| Height | Depth | Width | Width | |
|
|
|
|
|
|
|
18" |
| 17" | 13" |
| 28" | 20" |
24" |
| 17" | 13" |
| 28" | 21" |
30" |
| 17" | 13" |
| 34" | 24" |
|
|
|
|
|
|
|
* Measured at 13" depth.
Carefully follow the instructions below. This will ensure safe installation into a masonry, UL127- listed manufactured fireplace, or listed
Minimum Clearances for Side Combustible Material, Side Wall, and Ceiling
A.Clearances from the side of the fireplace cabi- net to any combustible material and wall should follow diagram in Figure 4.
Example: The face of a mantel, bookshelf, etc. is made of combustible material and pro- trudes 3 1/2" from the wall. This combustible material must be 4" from the side of the fire- place opening (see Figure 4).
Note: When installing your gas logs into a manufactured firebox, follow firebox manufacturer’s instructions for minimum clearances to combustible materials.
B.Clearances from the top of the fireplace open- ing to the ceiling should not be less than 42 inches.
Example |
* |
*Minimum 16 inches from Side Wall
Figure 4 - Minimum Clearance for
Combustible to Wall
NOTICE: Manual control heaters may be used as a vented prod- uct. If so, you must always run heater with chimney flue damper open. If running heater with damper open, noncombustible material above fireplace open- ing is not needed. Go to Install- ing Damper Clamp Accessory for Vented Operation, page 11.
Minimum Noncombustible Material Clearances
If Not Using Mantel
Note: If using a mantel, proceed to If Using Mantel. If not using a mantel, follow the information below. You must have noncombustible material(s) above the fireplace opening. Noncombustible materials (such as slate, marble, tile, etc.) must be at least 1/2 inch thick. With sheet metal, you must have noncombus- tible material behind it. Noncombustible material must extend at least 8" up (for all models). If non- combustible material is less than 12", you must in- stall the fireplace hood accessory (24" and 30" mod- els only). See Figure 5 for minimum clearances.
IMPORTANT: If you cannot meet these minimum clearances, you must operate heater with chim- ney flue damper open. Go to Installing Damper Clamp Accessory for Vented Operation, page 11.
www.desatech.com | 9 |
