OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 6 under Lighting In- structions, pages 19 and 20.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 20.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: CGHRCTB
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Ad- just flame adjustment knob anywhere between HI and LO. Slide the selector switch to the RE- MOTE position (see Figure 34). Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
Flame Adjustment | Control | ||
Knob | |||
Knob | |||
|
| ||
IH |
| PIL | |
ON | F | OT | |
O F | O | ||
OFF |
| ||
| N | ||
REMOTE |
|
| |
LO |
|
|
Selector Switch in Remote Position
Figure 34 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL CGHRCB)
Hold the control button on the
TO LOCK press both buttons on
TO UNLOCK press both buttons together on
Control Button
Turns Burners
On and Off
Figure 35 - On/Off Hand-Held Remote
Control Unit (CGHRCB)
THERMOSTAT SERIES (MODEL CGHRCTB)
The
| Turns Hand- | |
Digital | Held Remote | |
Display | On or Off | |
Shows | and Allows | |
Temperature | You to | |
and Settings | Choose the | |
Turns | Manual | |
Setting | ||
Burners On | ||
Selects Auto | ||
or Off | ||
Decreases | Setting | |
Increases | ||
Room | ||
Temperature | Room | |
in AUTO | Temperature | |
Mode | in AUTO | |
Locks System to | Mode | |
Prevent Accidental |
| |
Ignition |
|
Figure 36 - Thermostat
www.desatech.com | 21 |