Goodman Mfg GME8 manuals

16 pages307.02 Kb

2PRODUCT IDENTIFICATION
- WARNING
- WARNING WARNING
- G M E 8 070 3 B X C A
3PRODUCT IDENTIFICATION
- GME80703BXC* GME80905CXC* GME81155CXC*
  - All models are low NOx models.
- WARNING
  - 4WARNING
    - Part Numbe r 20162903 Open Set ting ( F) 160 GME80703BXC* 1 GME80905CXC* 1 GME81155CXC* 1
    - PRIM AR Y L IM IT
    - GME807 03BXC* GME809 05CXC* GME811 55CXC*
    - 7GME80 703BX C* GME80 905CX C* GME81 155CX C*
      - GME80703BXC* GME80905CXC* GME81155CXC*
- Coil Matches:
- Coil Matches (for Goodman units using R22 and R-410A):
8C A P F 1824 A 6 A
- 9Thermostats:
  - NOTE: Complete lineup of thermostats can be found in the Thermostat Specification Sheets.
- Filters:
  - Upflow Filters
- 10Dual$aver Configuration & Operation
  - Dual$aver
- 11FURNACE SPECIFICATIONS
  - MODEL
- BLOWER PERFORMANCE SPECIFICATIONS
12()
- Tons AC at 0.5" 0.6 0.7 0.8 ESP CFM RIS E CFM R ISE C FM RI SE CF M RIS E CFM RISE C FM C FM C FM
- 0.1 0. 2 0.3 0 .4 0. 5
- BLOWER PER F OR MANCE
  - (CFM & Te mper atu re Ri se v s. Ex te rnal Stat ic P ress ure)
  - EXTERNAL STATIC PRESSURE (Inches Water Column)
  - Motor Speed
- 13BLOWER PERFORMANCE SPECIFICATIONS
- 14WIRING DIAGRAMS
  - 8 FLASHES = CHECK IGNITER OR IMPROPER GROUND
  - DEPRESS
  - RECENT,
  - LEAST
  - RECENT
  - MOST
  - FAULTS,
  - 5
  - LAST
  - THE
  - RECALL
  - 6.
  - FIELDGND
  - IGNITER
  - CONNECTION
  - PLUG
  - LOW
  - (115V)
  - HI
  - JUNCTION
  - TERMINAL
  - OVERCURRENT
  - DEVICE
  - (TEMP.)
    - LGND
  - DEVICE
  - PROTECTION
  - POWER
  - HZ
  - /60
  - 1
  - 115VAC/
    - NOTES:
    - RATING OF AT LE AST 105
    - WH WHITE
    - BL BLUE
    - GY GRAY
    - BR BROWN
    - GR GREEN
    - BK BLACK
    - YL YELLOW
    - OR ORANGE
      - 1 FLASH =
      - 2 FLASHES = PRESSURE SWITCH STUCK CLOSED
      - 3 FLASHES = PRESSURE SWITCH STUCK OPEN
      - 4 FLASHES = OPEN HIGH LIMIT
      - 5 FLASHES = FLAME SENSE WITHOUT GAS VALVE
      - 7 FLASHES = LOW FLAME SIGNAL
      - RAPID FLASHES = REVERSED 115 VAC POLARITY/VERIFY GND
    - 1. SET HEAT ANTICIPATOR ON ROOM T HERMOSTAT AT 0.7 AMPS.
    - INTEGRATED CON TROL
    - 4. BLOWER SPEEDS SHOULD BE ADJUSTED BY INSTALLER TO MATCH THE INSTALLATION
    - REQUIREMENTS SO AS TO P ROVIDE THE CORRECT HEATING TEMPERATURE RISE AND THE
    - REPLACED, IT MUST BE REPLACED W ITH WIRING MATERIAL HAVING A TEMPERATURE
    - C. USE COPPER CONDUCTORS ONLY.
    - 5. UNIT MUST BE PERMANENTLY GROUNDED AND CONFORM TO N.E.C. AND LOCAL CODES.
      - SERVICING.WIRING TO UNIT MUST BE
      - PROPERLY POLARIZED AND GROUNDED.
  - DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
  - UNIT. MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE TO
  - DISCONNECT ALL POWER BEFORE SERVICING OR INSTALLING THIS
  - HIGH VOLTAGE!
- GME8_CA
  - WARNING:DISCONNECT POWER BEFORE
  - INTERNAL TO 2. MANUFACTURER'S SPECIFIED REPLACEMENT PARTS MUST BE USED WHEN SERVICING.
    - SYSTEM LOCKOUT (R ETRIES/RECYCL ES EXCEEDED)
    - STEADY ON = NORMAL OPERATION OFF = CONTROL FAI LURE
    - 6 FLASHES = OPEN ROLLOUT OR OPEN FUSE
  - COLOR CODES: PU PURPLE
  - PK PINK RD RED
  - SUPPLYWITH OVERCURRENT
    - N
  - SPLICE
  - (PRESS.) PROT.
  - EQUIPMENTGND
  - (24V)
    - PM 1HIC32
      - 24 VAC HUMIDIFIER
  - FOR
  - MORE
  - THAN
  - 2
  - SECONDS
  - WHILE
  - IN
  - STANDBY(NO
  - THERMOSTAT
  - INPUTS).
- 15WIRING DIAGRAMS
  - DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
    - FIELD GND
    - IGNITER
    - PLUG CONNECTION
    - LOW VOLTAGE FIELD
    - HI VOLTAGE (115V)
    - HI VOLTAGE FIELD
    - JUNCTION
    - TERMINAL
    - OVERCURRENT
    - SWITCH (TEMP.)
    - WH WHITE
    - BL BLUE
    - GY GRAY
    - BR BROWN
    - GR GREEN
    - BK BLACK
    - YL YELLOW
    - OR ORANGE
      - 1 FLASH =
      - 2 FLASHES = PRESSURE SWITCH STUCK CLOSED
      - 3 FLASHES = PRESSURE SWITCH STUCK OPEN
      - 4 FLASHES = OPEN HIGH LIMIT
      - 5 FLASHES = FLAME SENSE WITHOUT GAS VALVE
      - 7 FLASHES = LOW FLAME SIGNAL
      - RAPID FLASHES = REVERSED 115 VAC POLARITY/VERIFY GND
    - INTERNAL TO
    - INTEGRATED CONTROL
  - UNIT. MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE TO
  - DISCONNECT ALL POWER BEFORE SERVICING OR INSTALLING THIS
  - HIGH VOLTAGE!
- GME8_CB
  - LGND
  - POLARIZED
  - AND GROUNDED.
  - DISCONNECT POWER
  - BEFORE SERVICING.
  - WIRING TO UNIT
  - WARNING:
  - MUST BE
  - OVERCURRENT PROTECTION DEVICE
    - SERVICING.WIRING TO UNIT MUST BE
    - PROPERLY POLARIZED AND GROUNDED.
    - WARNING:DISCONNECT POWER BEFORE
  - 0140F00658 REV. A
    - SYSTEM LOCKOUT (RETRIES/RECYCLES EXCEEDED)
    - STEADY ON = NORMAL OPERATION OFF = CONTROL FAILURE
    - 6 FLASHES = OPEN ROLLOUT OR OPEN FUSE
    - COLOR CODES: PU PURPLE
    - PK PINK RD RED
    - PROPERLY
      - N
    - FIELD SPLICE SWITCH (PRESS.) PROT. DEVICE
    - EQUIPMENT GND
    - LOW VOLTAGE (24V)
      - PM 1HIC23
        24 VAC HUMIDIFIER
      - 8 FLASHES = CHECK IGNITER OR IMPROPER GROUND
- 16SCHEMATICS
  - TYPICAL SCHEMATIC GME8 ____** MODEL FURNACES WR 50M56-289 INTEGRATED IGNITION CONTROL

Goodman Mfg GME8 manuals

Goodman Mfg GME8 Service Manual

Goodman Mfg GME8 Manual