Graco Inc 1020 manuals

20 pages1.06 Mb

INSTRUCTIONS-PARTS
I
- Box
- RO.
  - INC.
  - GRACO
    - hose
      - wand assembly,
    - gun
      - Water supply tank,
      - bar)
      - 1300
        bar)
    - (69
      - Volt,
        10
      - Volt,
        bar)
      - psi
        bar)
      - 700psi.(48
    - 3
      - Volt,
- LIST
  - 0,720,
- HYDRA-CLEAN
  - 0,1020
- Pressure Washer
  - .
    - assembly and motor starler are not included.
  - 1441 MINNEAPOLIS, MN 55440-1441
  - 2HIGH
    - PRESSURE SPRAY CAN CAUSE SERIOUS INJURY FOR PROFESSIONAL
      - to
      - the
        6.
        To
        hand
        a
        Do
        Is
        in
        to
        or
      - try
        NNER
        NNER
        skin
        all
    - Read and understand
      - USE
        ONLY. OBSERVE ALL WARNINGS.
    - instruction manuals before operating equipment.
      - FLUID INJECTION HAZARD
        off.
      - GROUNDING INSTRUCTIONS
      - 3alter
        3
        SURE
        BE
        as
        1-
        to
        This
        NEVER
        to
        is
        to
        To
        with
        Is
        of
        to
        for
        of
        DANGER
        of
        GROUND FAULT CIRCUIT INTERRUPTER PROTECTION
        70)
        EQUIPMENT MISUSE HAZARD
        General Safety
        System Pressure
        Chemical Compatibility
        in
        308-533
  - 4HOSE
    - SAFETY
      - 308-533
        to
    - or
      - NNER
      - or
        CLEAR
        KP
        Procedure
        Relief
        Pressure
        PARTS
        MOVING
        DO
        -40'
        (93'
        to
        tape
        try
        NNER
        in
        to
        MUST
        ALL
        due
        or
      - HAZARD
        TERMS
    - IMPORTANT
      - INSTALLATION
      - 5for
        must
        (70'
        Do
        P/N
        from
        Install
        of
        to
        a
        off,
        any
        to
        Connect
        carrler
        Is
        UP.
        CAUTION
        STARTUP
        6are
        308-533
        Use
        Be
        dly.
        run
        off
        so
        to
        DO
        5.
        is
        be
        to
        or
        20
        to
        CAUTION
        the
        CAUTION
        Safety
        7onto
        to
        the
        3.
        2.
        Over
        and
        use
        To
        Installing
        Trigger
        or
        the
        in
        fluid
        To
        Latch WARNING
        2.
        Changing Spray Tips WARNING
        (A),
        3.
        3
        308-533
        SHUTDOWN, FLUSHING AND STORAGE
  - 8.
    - To
      - 6
      - Wamlng
        500
      - oil.
        WARNING
        oil.
        20
        for
        is
        inlet
        See
        use,
        NOT
        DO
        If
        must
        of
        the
        6.
        5.
        off
        2.
        the
        To
        CAUTION
      - MAINTENANCE
        Use
        do
        WARNING
    - TROUBLESHOOTING
9I
- for
- on
- more
  - See
- CHART
- I
  - I
- I
  - Scored.
  - I
I
- parts,
- moving
  - on
  - or
- in
  - bodily
  - serious
    - risk
  - the
    - To
- WARNING
  - or
  - proceeding.
- -.
  - 308-533
  - PUMP
    - SERVICE
      - Figure
        4).
        8.
        7.
        soft
        1.
        5
        14.4
        6.
        using
        Remove
        4.
        to
        an
        803-666.
        803-664
        800-298
        of
        800-298
        to
        Warnlng
        803-677
        of
    - To
      - Servicing the Plungers
        to
  - 10-
    - in
    - 800-271
    - Valves
      - 801-474. 4.
        as
        1.
      - 2.
        3.
    - Pumping Section
      - CAUTION
        to
        Torquethescrewsto21.7ft-lb(29Nm)followingthe
    - Servicing the V-Psckings
      - for
        as
        will
    - 11out
      - types
        3.
      - two
        NOTE:
      - CAUTION
        308-533
    - PARTS DRAWING
    - 129
      - PARTS
13r
- 3
- Volt,
  - Wlrlng
    - hp
- LIST
  - hp,
    - 801
  - 20
    - H
      - 800-902
    - 2
  - S
    - 710
    - Hydra-Clean@
    - 800-902
    - Pressure Washer
    - 1010
    - Hydra-Clean@
      - 800-903
    - Pressure Washer
      - 8
      - 800-447
- 803-m
  - -020
    - QTY
    - 22
      - 40
  - 800-445
  - 800-688
  - 14PARTS
    - DRAWING
  - PARTS
- 15S,,
  - 3
    - Volt,
  - 230
    - Wring
    - 15
  - LIST
    - 20
    - NO.
      - on1
        800-004
        (lor
      - Lock
      - 803-560
      - 802-845
        NO.
        1020
      - Hydra-Clean@
        800-905
    - Pressure
    - Hydra-Cleans
      - 800-904
      - Washer
        8
        8w-444
        hp
        QTY
        REF
        20
        27
      - NO.
        QTY
        1
        4
        2
        Diagram
        NO.
  - KCI
    - No. No.
    - NO.
    - 803-633
    - 803-606
    - 20
      - REF
    - NO.
      - 803-605
        3
        803-609
        6
        803-608
        3
        37
      - QTY
      - 33 6 803-630
      - 803-653
      - 6
      - 803-638
      - 6
        3 3
        48
        3
  - am
    - a
    - W.
- 17I I
  - 308-533
  - PARTS
    - LIST
      - 18
      - 803-643
        803-620
        803-648
      - 803-659
        NO.
      - Assembly,
        Pump
        803-578
        GPM
      - REF
        QTY
        KR
        No.
        50
  - -
    - RING,
191; 1
- I: I
  - I1 I
    - ACCESSORIES
      - purchased
        or
    - TECHNICAL
      - x
      - 50
        x
        wand
      - ASSEMBLY WITH QUICK COUPLERS
      - HOSE
        60
        into
        of
        5.5
      - be
        (Must
        separately)
        GPM (21 LPM) 800-425 BRASS 5.6 TO 10.8 GPM (21 TO 41
        INLET PRESSURE REGULATOR 800-258
        800-042 800-375
    - 20DATA
      - or