FILE NAME ( W505Operation.pmb) RAS 09-12-06
Casablanca Fan Co. - Factory Service Department - Technical Library
2
Wall Installation
Step A. Locate a 2x4 wall stud
in a convenient location.
Step B. Orient the control
bracket as shown over the 2x4
stud.
Step C. Use the 1” wood
screws in either the inner or
outer mounting holes. Install
and tighten screws by hand
only.
Note: The wall anchors and 6-32 x 1”
screws may be used in situations where
mounting to a stud is not possible. Use the
inner mounting holes. After securing the
anchor, discard the anchor’s pointed
screws and use the 6-32 decor ovalhead
screws supplied.
Changes or modifications not expressly approved
in writing by Casablanca Fan Co. may void the
user’s authority to operate this equipment.
DECOR OVALHEAD SCREWS
W-505™ CONTROL BRACKET INSTALLATION
This device complies with RSS-210 of Industry Canada. Operation is subject
to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
W-505™ BATTERY INSTALLATION
Install Battery
Press battery into control aligned as
shown.Observe proper polarity. Replace the
battery door.
Remove Battery Door
Turn control on its front. Twist a coin or use
your finger to unsnap the door A. Lift door
away from control B and remove C.
Changes or modifications not
expressly approved in writing by
Casablanca Fan Co. may void
the user’s authority to operate
this equipment.
This device complies with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
DRYWALL ANCHOR
12V BATTERY
Wall Controls - CONTINUED
Wall Controls - CONTINUED
Wall Controls - CONTINUED
W-505™