FILE NAME ( W505Operation.pmb) RAS 09-12-06
Casablanca Fan Co. - Factory Service Department - Technical Library
4
CHECKING THE SWITCH SETTINGS
You will only have to change the dip switch settings in
the remote if you are using more than one fan in the same
area and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power
off for the fan you want to change.
Step 2. Open the battery door of the Prime•Touch control
and remove the batteries.
Step 3. Change the dip switch settings, assuring that
they are different from the previously installed Prime•Touch
fan.
Step 4. Re-install the batteries and the battery door on
the control.
Step 5. At the circuit breaker or fuse box, turn the power
back on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the
HIGH, MED, and LOW buttons (in that order).
Note: All fans leave the factory set to “0000.”
Note: You may want to label your controls to assure
you do not mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed
correctly in the control.
Step 2. Turn the power off to the fan (from the circuit
breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker)
and push
the HIGH, MED, and LOW buttons–in that order–within
20 seconds.
Step 4. The fan should now function properly.
WARNING!
Do not turn the power off at the circuit breaker,
then back on, for the previously installed
Versa•Touch2 fan(s), as you may inadvertently
change the frequency settings for it as well.
Dip Switch
Set to “1000”
Dip Switch
Set to “0101”
Circuit Breaker
Box