4LinkBuilder FDDI Workgroup Hub User Guide Release Note
After flash memory has been verified, the status LED turns green when the system is fully initialized. Within a short time, the modem initialization string AT&F is briefly displayed. When the AT&F display disappears, you can access the management console command mode by pressing [Enter].
When there is no active console session or if a console session times out, AT&F will be displayed periodically to determine if a modem is present. You must wait for the AT&F to disappear before pressing [Enter] to enter the management console command mode.
Page 5-20: route dump and route add Commands
Changes have been made in the route command display and description. When you enter the route dump command, a metric value appears in the subsequent display, as explained below:
■
■
A metric of 0 indicates that the entry is a host.
A metric of 1 indicates that the entry is a gateway.
You can include a metric of 0 or 1 with the route add command. If you enter a value greater than 1, it is converted to 1. If the metric is not entered, 1 is assumed, which designates the entry as a gateway.
The default gateway, whether entered using the route add command or the set gateway command, sets the metric to 1 regardless of the metric option given.
The metric option does not indicate the number of hops to the destination network, as stated on page
Page 5-21: Fault Log Display
A reset count has been added to the fault log display header. When you enter the show log command, the fault log header appears, as shown in the example below:
Fault Log: [# | 10] |
The number corresponds to the number of times the hub has been reset and allows you to correlate fault log entries with a given reset shown in the fourth column of the display.