3Com 3C16702A manual Stacking the Units together, Rubber Feet, Stacking Clip

If you want to connect additional hubs using 10BASE-T, you need:

■One ‘Straight-through’ 10BASE-T cable for each additional hub.

Stacking the Units together

The Rubber Feet

The four self-adhesive rubber feet prevent your hub from moving around on your desk. Stick the feet to the marked areas at each corner of the underside of your hub. Do not fix the feet if you are going to use the clip.

The Stacking Clip

The stacking clip allows you to stack your OfficeConnect units together neatly and securely.

CAUTION: You can stack up to a maximum of four units. Smaller units must be stacked on top.

To fit the clip:

1Place your unit on a flat surface.

2Fit the clip across the top of the unit, as shown in Figure 2 (picture 1), ensuring that the longer sections of the fastening pieces are pointing downwards.

3Align the fastening pieces over the slots found on each side of the unit.

4Push the clip down gently to secure it, ensuring the fastening pieces snap into the slots on the unit.

To fit another unit:

1Rest the second unit on top of the clip and align it with the front of the unit below.

2Press down gently on the unit to secure it onto the clip, ensuring the fastening pieces fit into the slots on the unit below, as shown in Figure 2 (picture 2).

Figure 2 Stacking Your Units Together

1	Fastening	2
	Piece
		Fastening
		Piece

To remove the clip:

1Remove the top unit together with the clip. If you hook a finger around one of the the fastening pieces and then pull it gently from out of the slot, the clip should come away with the upper unit attached to it.

2Push the clip in the center, so it bends towards the base of the unit, and then separate once the clip is loose.

9